1) Check the power cord for any burn marks.

2) Connect the AC power cord into here.

3) Accessories included: An AC power cord.

4) Use the proper power cord with a ground conductor.

5) Apply to power cord, shield wire, computer cable etc. With full stripping or Half-Stripping select as need.

6) To replace the power cord should be used with the cable model and a professional replacement.

7) Accessories: a remote control, a power cord, a user manual, a lens paper, a product certification, a signal line, a back-up insurance control.

8) Disconnect power cord for another 10 secs and then reconnect.

9) Power On the unit: Securely connect the AC power cord to the unit and mains power.

10) Fully unwind the power cord and plug it into an earthed socket.

11) AC power cord must be changed only at the qualified service shop.

12) Do not water when the unIt'so that cable,[http:///power cord.html] power cord so as to avoid fracture.

13) If the power cord is damaged, in order to avoid a hazard, you have to send the appliance to Philips, Philips authorized service center or qualified technicians replace the power cord.

14) Other than the power cord, you don't have to hook any cables into the Panasonic TC - P 54 Z 1.

15) For ceiling wiring, pass the power cord through spool rest rod 2.

16) Thread power cord down through motor hole and out to the back of the turntable.

17) Remove power cord and insert the JigKick Battery into the PSP.

18) Suit for AC/DC power cord, electronic wire, flat cable and coaxial cable.

19) Be familiar with the international safety standards power cord - reel.

20) Plug the power cord for the monitor into a nearby outlet.

21) For power cord, The client whether approved the confirmatory sample?

22) Hometheater systems inevitably result in a cluster of cables and power cords.

23) WARNING: DO NOT step on or place anything over the power cord.

24) Should a power outage occur (UPS in stand-alone mode), do not disconnect the power cord from the mains, as this will break the earth connection to bonded appliances.

25) Established in 1992. Main products is PVC and Rubber Power Cord and Plug.

26) The second circuit is supplied with electricity by a second power cord and receives a character line selection signal of the corresponding character line.

27) The utility model solves the problems that when the speed of the vehicle is increased, the power cord can strike fire and the components have short service life and large quantity of repair.

28) Open the front door have observed the power box light is lit, then check if there is light scanner power cord is plugged into the output plug on the transformer.

29) The read lead (with the inline fuse) of the supplied power cord is to be a "hot" (positive) wire, and the black lead to ground .

30) A terminal line block is arranged in the front of the lower riveted knife. A power cord can be automatically placed into the position feeding stamping device without manual operation.