1. Thirdly, we investigate the impact of the pull-in voltage on the nonlinear vibration detailedly, and get the relationship between the physical parameters and the pull-in voltage.

2. In the past, the pull-in parameters of parallel plate MEMS devices with the fringing field effect are often estimated using finite element method (FEM).

3. A simple set-up has been designed to investigate the mechanism of pull-in of rolling faces of electromagnetic casting (EMC) slabs.

4. It can be used to improve PLL signal acquisition and cut down the pull-in time.

5. Permanent magnet synchronous motor running from asynchronous start-up to pull-in synchronization is a very complex electromechanical transient process.

6. This paper describes a new decoder, the phase stability and no pull-in time,(http:///pull-in.html) and gives the measurement results.

7. At the same time, the results reveal the relationship that the period of response is proportional to the driving voltage, and the character that dynamic pull-in voltage is.

8. A novel method for calculating Youngs modulus and residual stress of a MEMS film is proposed based on pull-in voltages of a set of fixed-fixed beams.

9. An electrostatically actuated in-situ measuring method for average stress gradient and elastic modulus of a MEMS film was proposed based on pull-in voltages of a set of cantilevers.

10. A set of experiment is designed to quantitative compare LZD and ICP performance, including pull-in range, iterative convergence rate and calculational efficiency.

11. An electrostatically actuated in-situ measuring method for average stress gradient and equivalent elastic modulus of the film is proposed based on pull-in voltages of a set of cantilevers.