1) In engineering, in order to make the weld line even and reliable, it is needed to cut the weld opening accurately.

2) It also shows a method to control the weld line movement.

3) Pinhole. A short unwelded area in the weld line extending through the entire pipe so that fluid will leak out through the area very slowly.

4) It is weld line.

5) Contact Mark. Intermittent marks adjacent to the weld line resulting from the electrical contact between the electrodes supplying the welding current and the pipe surface.

6) Detecting the weld line and its edge directly by visual sensor can achieve much useful information,[http:///weld line.html] which is very important in the research of weld line automatic tracking.

7) The classification and characteristics of weld line of injection-molded parts are introduced.

8) Too high switch point: empty part, weld line, sink mark, and small.

9) And finally, they enhance the forming depth and reduce the weld line movement through the numerical simulation.

10) For the modified frame design, fatigue life and damage calculation results, by means of this approach, show that the ability of anti-fatigue damage at the weld line has been improved significantly.

11) Variations in the properties of the weld occurring at short regular intervals along the weld line due to repetitive variation in welding heat.

12) The variation in properties gives rise to a regular pattern of light and dark areas visible only when the weld is broken in the weld line.

13) This method can be more accurate study of material properties, intensity ratio on the impact of TWBs springback and weld line movement.

14) Weld Area Crack. A crack in or immediately adjacent to the weld line.

15) By comparing analysis results, the best moulding project is chosen filling effect being unifor with unobvious weld line and centralizing air traps.

16) Some statistics methods, such as the Monte Carlo method were used for data mergence and allocation, and a case of auto weld line was given to depict how to carry out data uncertainty analysis and sen...

17) Drop transfer in the process of MIG welding is very complicated and quality of weld line is easily impacted by welding parameters coupled with each other.

18) Among the processing factors, packing pressure exhibits the most significant effect on weld line strength.

19) This article introduces the technological method of using glass fibre tubes to solve the splitting problem from the weld line after the forming of the thermosetting product "pedestal".

20) The results show that the method can effectively resolve the TWB forming process parameters, and that the weld line movement can be reduced by more than 75%.