(1) The term mol -1 thus means per mole of this specified equation.

(2) It is proved that the MOL resolution principle is complete.

(3) Brian Mol ineaux, a night porter, collapsed at his home in Chelmsford, Essex, before he could feed his 17-year-old pet, called Budgie.

(4) The DNA base composition is 32.6 - 33.1 mol % guanine plus cytosine.

(5) Due to the lower mol ratio of the methyl carbonate to the glycerol, the consumption of the methyl carbonate is lowered.

(6) The officer at MOL will vet and scrutinize the documents.

(7) The molar absorptivity is 2.14×104 L · mol - 1· cm - 1 for calcium . Recovery is up to 99.1 %.

(8) MOL will continue to monitor the development and keep you post in due course.

(9) The effect of 100μ mol · L - 1 SNP was best.

(10) Compounds with bond energy of 180-260 kJ/mol were considered as good initiators for initiated cracking of n-heptane and nitroethane was the best in the used initiators.

(11) The mol contents of the adulterated Zn in SnO _ 2 are 1 %, 2 % and 3 %.

(12) But in 1 mol NaOH or HCl they lost its moving ability.

(13) BCS theory is used to calculate the moments of inertia (Mol) of odd-A and even-even rare-earth nuclei.

(14) And the mol of Ca element in Mylabris was lower than that of the bound cantharidin.

(15) To rub salt into the wound, they had Michael Mols sent off.

(16) The Curie temperature of LSMO lowers successfully to room temperature with 0.07 mol ratio Ti 4 + addition.

(17) This article discussed the influence factors of productivity of formic acid such as the mol ratio of sodium formate and phosphoric acid, the addition of phosphorus pentoxide, vapouring temperature.

(18) It was found that aluminum salt(AS) was an effective accelerant and when the mol ratio of AS to TA was 2:1, the angle of untwist crease was optimized but the hand feeling was poorer.

(19) Since the heat of atomization of KrF2 is only 23 kcal per mol, this implies that ArF2 cannot be made.

(20) The efficiency of DBDMH production is 90%with an optimum mol ratio of 1:2:2 of hydantoin: Br2: NaOH.

(21) Average foams life, has been presented as criterion to evaluate the foaming behavior in mol - ten slag.

(22) The cis pathway has the lower entrance energy barrier ( 20.9 kJ · mol - 1 ).

(23) The highest ethylene oligomerization activity of the Ni ( II ) complexes is 9 . 15×10~5 g · mol ~ ( - 1 ) ( Ni ) · h ~ ( - 1 ).

(24) Then, several improvements are made, and a modified ordered linear resolution principle, MOL resolution, is presented.

(25) The respiratory rate and catabolism pathway are described respectively by using relative mol number of consumed oxygen during unit time and respiratory quotient.

(26) The results showed that: (1) Nymph of periplaneta americana was the most important allergic species in this area; its active part was in F2 with Mol.

(27) RCR is the ratio of R3 and R4. ADP/O is the ratio of mol of produced ATP while one gram atom oxygen is consumed within mitochondria.

(28) The latest agreement positions Honeywell as a key automation solution supplier for MOL.

(29) Mattson M. P. "Apoptosis in neurodegenerative disorders. " Nature Rev. Mol. Cell Biol. 1 (2000): 120-29.

(30) The thermoluminescence ( TL ) glow curves and 3 D emission spectra of SrSO _ 4 : Eu (( 0.1 ) mol % ) powder sample were measured.

(31) Examples are given to differentiate quantity ratio and mass fraction, mol ratio and mol fraction, cuba.

(32) After treated with L NNA 250μ mol, the resting vascular tone of COC group was much higher.

(33) And by applying biogas slurry, photosynthesis rates is 16.622 μ mol · cm - 2· s - 1 , improving 26.029 % by CK.

(34) The results show that coupling the PET/Polyolefine blends by g not only enhances strongly the mol. wt. of PET, but also promotes the growth rate of PET crystallization.

(35) The function of the assembling of the injection mol ding screw head is very important for pressure control during molding operations .