1. This suggests that careful annealing at the appropriate temperature could produce samples with a high degree of crystallinity.

2. Annealing was the heating and slow cooling process by which the resulting metal was toughened.

3. Simulated annealing uses random perturbations to shake the parameter values out of a local optimum so that globally optimal values may be found.

4. This led to an early invention of annealing, whereby the metal might be softened by sudden heating and quenching.

5. Why shall harden steel be annealed?

6. Tool steel is generally purchased in the annealed condition.

7. The measuring results temperature resistance of the sample annealed at 500℃ was indicative of kondo effect.

8. The results show that the ECP of the annealed copper alloys for lead frames can be predicted by the model.

9. The Positron lifetime spectra of unannealed and annealed Ni-coats, electro-plated from the four typical baths, have been measured.

10. Bearing cones must be annealed prior to machining and a subsequent post heat-treat hardening.

11. Procedure: annealed, eddy current detection, alignment, rounded, hydrostatic testing, pickling, product inspection.

12. Appreciate those who hurt you, because he annealed your mind.

13. While annealed in the atmosphere, nano - crystalline LaF _ 3 was oxidized over 500 ? ? C.

14. RPP Milling, turning, planning of cast iron, annealed cast iron, steel, austenitic steel.

15. Lead or annealed copper washers are most often used in fluorine and other reactive fluoride service.

16. The annealed copper stranded wires are made of high quality copper round wires or tinned annealed copper round wires .

17. The experiments show that the microstructure of annealed sample is favourable to improving reverse breakdown voltage.

18. An abbreviation for " hot rolled annealed and pickled. "

19. A close approximation to these conditions has been attained by Mandelkern, who annealed a linear polyethylene for 40 days.

20. The purity of high pure aluminium used for high voltage anode of electrolytic condenser and effect of process on annealed structure are studied.

21. UV absorber BAD is prepared with phenol, acetone, and salicylic acid as primary materials. The proper binding about acid agents and the annealed solvent are selected.

22. The GMI ratio of about 114 % is obtained in near zero-magnetostrictive Co-based amorphous alloy ribbon annealed by short time rectangular pulse current.

23. The experimental results indicated that the film resistivity of the sample annealed was reduced significantly and only one 3.17 of the unannealed.

24. DNA that is mainly composed of repetitive sequences. It is denatured genomic DNA are re - annealed.

25. Recrystallized microstructure and mechanical properties of cold worked brass annealed by electropulsing and routine annealing were studied.

26. The solder joint exceeds the strength of Type L tube in annealed temper.

27. High-speed tool steels, hot and cold processed steels, rust-resistant steels, annealed steels and carbides.

27. try its best to gather and make good sentences.

28. XRD structural analysis shows that peak intensity of the annealed sample is greater than that of the unannealed one which demonstrated an increase of crystallinity.

29. The ductile-embrittlement transition temperature of vermicular graphite cast iron increased with increasing phosphorus content both in the as-cast and annealed condition.

30. Analysis by XPS graph obtained silicon atom ratio of oxygen is about 1:1, the results showed that the films were annealed silicon oxide film is rich silicon oxide.

31. The transmittance of the YSO H _ 2 - annealed obviously decreases after radiation in the 200 - 500 nm spectral ranges.

32. The films also can be annealed in air or reductive circumstance according to the requirement.

33. We produce the annealed wire with high - quality low carbon raw materials through wire drawing, anneal process.

34. The resistivity of pyrophosphate and annealed acid sulfate copper deposits are substantially equivalent.

35. The CPC electronic packaging materials have the best integrated properties when annealed under the temperate.

36. The crystal morphology, microstructure and hydrogen - annealed formation process has distinct impact on the sag resistance.

37. Therefore, some measures, such as improving the quality of tube billet and the technologies of cold-draw and annealed in process, were found out. And the good effect was obtained.

38. In the first, it is annealed, meaning it is run through a furnace to be softened.

39. The results show that the vanadium oxide thin films are reduced more easily when annealed in low vacuum than when annealed in high vacuum.

40. A well - annealed material may require many days of contact with water.

41. The annealed walls froze all the rigid grief of the actress.

42. Both tensile strengths decrease when annealed at temperature higher than 920 ℃.

43. However, the forward martensitic transformations were greatly suppressed in annealed Co and CoNi.

43. try its best to gather and build good sentences.

44. It is shown that the mechanical properties of annealed sample of 2224 aluminum alloy are improved by the combination of solid solution and aging treatment after ECAP, the size of grain is refined.

45. At no time should un - annealed glass apparatus be put into laboratory service.

46. Most nonferrous metals can be annealed, but never tempered, normalized, or case-hardened .

47. The LNO thin films annealed at lower temperature have (110) preferred orientation, while the films annealed at higher temperature have (100) preferred orientation.

48. Rough machining and semi - finishing of the material in its soft ( annealed ) condition.