1. End effects and errors due to misalignment are very important in torsion testing.

2. Sure, the bathroom door is weak with misalignment and it will not shut.

3. External pipe supports should be used to eliminate misalignment.

4. Influence of misalignment between SMF and FMF on depth of modulation(DM)was calculated.

5. Lugs should not be used to adjust misalignment in piping.

6. Axial motion and misalignment (radial and angular offset) between the encoder shaft and the drive shaft are compensated by the coupling.

7. There may also be misalignment between words, tone and body language, such as gestural slips, which are physical equivalents of speech errors and indicate internal conflicting thoughts.

8. Without the misalignment, coupling efficiency increases with the decreasing of taper length.

9. Additionally, the misalignment of the system could make the stability have a tendency to deteriorate.

10. In this paper, misalignment sensitivity of resonators for slab solid - state lasers has been studied.

11. The identification result of the gyro misalignment angle in inertial platform is unsatisfactory for the static multiposition test scheme.

12. Unique taper lock design avoids the misalignment problems that are common with traditional taper lock clamps.

13. Misalignment of teeth between the upper and lower jaws can grind down the teeth and cause problems in chewing. Elsewhere, it is a cosmetic problem.

14. Thrust vector misalignment is an important factor, which causes trajectory scatter and affects missile reliability.

15. Floating action compensates for mating hole misalignment, Available with locking or non-locking threads.

16. Palpation a step - off,[http://] or gross misalignment of the spinous processes may also reveal extensive underlying injury.

17. If there is misalignment of structure and systems, you will not have empowerment or trust.

18. Where misalignment between the inner and outer rings exceeds 1 minute of arc, the action of the load on the flange changes considerably.

19. This type of joint will allow a certain degree of misalignment when the pipe is laid.

20. The results indicated that the steady-state performance of dry gas seal was influenced unusually by roughness and static stator misalignment.

21. A model of the beam centroid motion in a linear induction accelerator (LIA) was developed. It calculates the track of the beam centroid under the condition of cell magnet misalignment.

22. These bearings typically offer high thrust load capability and dynamically compensate for any misalignment.

23. The contact path offsets to the tip and toe of face gear tooth due to it is sensitive to the alignment error especially the error of axis shaft error in the misalignment.

24. In a word , the researches provide strong computation methods for design of mini - thrust misalignment nozzle.

25. The establishment of failure rotor system response characteristic supports the monitoring and diagnosis of misalignment.

26. The most serious cause of dispersion is usually thrust misalignment.

27. The pentahedral bicharacteristic curve grid can be applied to investigate the thrust misalignment characteristics in a unsteady flow.

28. A phase spectra alignment algorithm was also developed for lower sampling frequencies which reduce the influence caused by detector misalignment while detecting tiny TWA amplitudes.

29. Self-aligning Ball Bearings are particularly suitable for applications where misalignment occurs from errors in mounting or from shaft deflection.

30. It shows that the contact path of the face gear drive is shift in the direction of the surface caused by misalignment.

31. If you already have a sacroiliac misalignment, the key is to adjust the joint back into its proper position and keep it there.

32. The pentahedral bicharacteristic curve grid can be applied to investigate the thrust misalignment characteristics in a unsteady f.

33. Folding-mark and slotting right-and-left are adjusted by way of simultaneous operation of four wheels to ensure the accurate position of both (no misalignment) for waste reduction.

34. This coupling connects the shafts in such a way asminimize the harmful effects of shafts misalignment.

35. During precise measurement of high reflectivity, cavity misalignment has great influence on reflectivity measurement results of ring-down spectroscopy.

36. The rear cone decentration and compact leg tilt can both result in a phase shear and twist on the optical field, and lead to phase jump and tilt along the misalignment direction.

37. The biggest risk comes from measures linked to China's supposed exchange - rate misalignment.

38. In most applications[], the double and twin models also either match or exceed the tolerances for misalignment offered by the recirculating ball pillow block .

39. Trichiasis , usually due to misalignment of lashes, is a very common and otherwise troublesome problem in routine ophthalmological visits.

40. Does Transaction Misalignment Matter for Firm Survival at All Stages of the Industry Life Cycle?

41. For example, ball and roller bearings can be of the self-aligning type to accommodate shaft misalignment and deflections .

42. Locating errors includes misalignment error with reference point and displacement error with reference point.

43. A recent study investigated the effects of real exchange rate misalignment and instability on economic performance.

44. The maximum allowable misalignment of the coupling is 0.02 mm.

45. The simulation on alignment and misalignment of a positive branch confocal resonator is described in the paper.

46. The growth regression on misalignment shows that misalignment has a significant negative effect on economic growth, specifically, overvalue does harm to growth, while undervalue may improve growth.

47. The errors of FOG involved with temperature are zero bias and scale factor. Input axis misalignment is another important error with temperature.

48. Check and adjust radial angular and axial misalignment both ends of coupling.

49. Based on the matrix method of misalignment resonator and experimental parameters, a theoretical model is proposed to simulate measurement of reflectivity for cavity mirrors' tilt in ring-down cavity.

50. Besides, correction effect of fundamental variables in the model to RMB rate misalignment is also elaborated.