1 The densification of said composite started at 1750℃ and ended at 1830℃.

2 To insure more densification but deformation of glass beads, the green density should be increased, and the burnout temperature of binder should be below the toplimit of transformation temperature.

3 Sintering densification behavior, hardness and grain growth characteristics of carbonyl iron powder prepared by spark plasma sintering (SPS) were studied.

4 The densification, microstructure and hardness of molybdenum prepared by spark plasma sintering ( SPS ) were investigated.

5 The mechanism of rapid densification by CVI includes magnetic attraction of radicals, electric deposition of radicals, and dehydrogenation and aggregation of radicals.

6 The sintering densification of dielectric paste had crucial effect on the insulation of stainless steel substrate.

7 The influencing factors and densification mechanism of iron - based high temperature alloy powder by pressing were investigated.

8 Extensive studies have been reported on the densification of densification of natural wet snow.

9 Bulk binderless ultrafine pure WC with nearly full densification was obtained by spark plasma sintering.

10 Densification mechanism of metal powder sintered with selective laser was studied.

11 This paper reviews different densification, models and describes Assmann - Stehle model in detail.

12 The microstructure, densification behaviour, electrical, ferroelectric and ferromagnetic properties of Ni - doped BaTiO 3 are measured.

13 The dynamic stress strain curves are similar to those obtained in the experiments of quasi static compression and can also be divided into the elastic region, yielding region and densification region.

14 By microstructural analysis of the densified coatings, the mechanism of the densification process was discussed.

15 High sintering temperature and long maintaining time lead to the sufficient crystallization and the full densification, but result in the worsening of the deviation from the stoichiometry.

16 Their compressive stress-strain curves are typically three-region curves, including elastic region, collapse region and densification region. And they show signally strain rate sensitivity.

17 This is because nano - silica can accelerate the sintering process and promote the densification of corundum castable.

18 In addition, the slope K value of gyratory compaction densification curve is analyzed in this paper.

19 From the point of volumetric design, the SUPERPAVE gyratory compactor(SGC) densification curves are used to evaluate the variation of volumetric properties of HMA during densification process.

20 For fire - type thick film paste, inorganic binder is necessary to provide adhesion and densification.

21 Ceramic stick: Production Process for dry - pressed alumina high - performance stability, good densification.

22 The product can degas and flow horizontally to effect densification by its own gravity without shock.

23 It is known that mineral admixtures lead to a densification of the concrete internal structure.

24 Microwave sintering of ceramics has the characteristics of quick densification, fine grains and homogeneous microstructure.

25 Comparing with ammonia and vacuum atmosphere, H 2 atmosphere was highly advantageous to densification of compounds.

26 This paper discussed the different influences of dry pressing on the densification of special ceramics.

27 The effect of the amount of fused magnesia addition on the densification of magnesia chrome refractory was investigated.