(1) CNC (CAD numerical control) lathe with single tool holder.

(2) The dynamical performance of the tool holder is detected and analyzed by real-time control experiment. An advanced control method called repetitive control is presented in the thesis.

(3) Disclosed is a surgical tool holder 11 adapted to connect to a disposable cutting tool 12 , and the surgical instrument 10 combination.

(4) The tool holder is small, com pact, noiseless, expecially its transmission is ...

(5) In technology of swap, the mechanism of tool holder tension very important.

(6) A software named MATLAB is utilized to the tool holder as the simulink and control software.

(7) The tool holder and shank can now be defined directly from a pattern.

(8) As part of design method of tool holder, practical performance parameters are measured by experiments and the measured data demonstrates the reliability of this method.

(9) A speed-raising tool holder which is drived by special traction agent is developed. Speed of tools can be raised8thimes without any change of the construction and spindle speed of machine.

(10) For collision detection, the tool holder can be built up from any number of cylinders and cones.

(11) Treatment methods normally through elevation turret tool holder with a knife.

(12) The achievement stated in this dissertation is important for utilization micro-feeding tool holder and improving the precision of the lathe machine.

(13) This design not only made an obvious simplification on the structure of cutter replacer but also enhanced the strengths of cutting tool holder and sliding frame as well.

(14) The simulation results are proved that the PID controller based on repetitive control is effective to the motion control of the tool holder.

(15) Method for controlling combined lathe apparatus, combined lathe apparatus, turning tool holder, blade position registering apparatus, and blade position detecting apparatus.

(16) The whole system includes four modules: industrial computer and its hardware module, signal detecting module, tool holder actuator module and control software module.

(17) This theoretical agreement leads with the user to the acceptance that thread taps can be used in rigid tool holder without problems.

(18) The main middle part of the article analyze the movement accuracy when the tool holder has deviation.