(1) If a triaxial vacuum feedthrough is unavailable, a metal safety shield should be built around the isolated BNC connection (Figure 4-18).

(2) Vacuum feedthrough, which is one of key components of the ion cyclotron range of frequencies (ICRF) antenna, is applied to seal for the ICRF antenna.

(3) For safety reasons, a triaxial vacuum feedthrough should be used if the bias voltage is more than 42V.

(4) Analyze the clock feedthrough error of the first-generation switched-current memory-cell and design a high performance switched-current memory-cell.

(5) The complementary switches are adopted to minimize clock feedthrough and charge injection of the switches.

(6) Position the power and ground feedthrough or abutment pins so that they align with corresponding pins in other cells.

(7) A new clock - feedthrough ( CFT ) compensation technology for switched - current circuits is described.

(8) The charge injection and clock feedthrough are reduced because the control signals of the switches are complementary. The charge sharing effect is prevented by bootstrapping.

(9) The calculations show that in the low wave number band, the outer surface is stable, while the feedthrough growth on the inner surface is rapid, resulting in the observed pha.

(10) The robustly dissipative synthesis problem is discussed for a class of affine nonlinear uncertain systems with input-output feedthrough.

(11) The CEC technique compensates the sampling bandwidth by eliminating the impact from finite on-resistance of the sampling switch, and avoids increasing clock feedthrough and charge injection.

(12) Traces on opposite sides of the board must run at right angles to each other. This reduces the effects of feedthrough on the board.

(13) If this is the case[Sentence dictionary], a simple coaxial vacuum feedthrough can be used to make connections from the collector to the picoammeter.

(14) If the bias voltage is less than 42V off ground, the isolated BNC vacuum feedthrough will not need a safety shield.

(15) A bootstrapped switch with dummy transistor is used to reduce the signal-dependent charge injection and clock feedthrough.

(16) A ceramic discharge vessel (8) for a high-pressure discharge lamp has a pin-like feedthrough (10) inserted in a plug (11) made from a composite material.

(17) In the fourth chapter, we discuss the passivation control problem for a class of nonlinear system with disturbance uncertainty and feedthrough term.