1. S. condition and coercivity of functional.

2. The temperature dependence of exchange bias and coercivity of ferromagnetic layer and antiferromagnetic gain layer is discussed.

3. The temperature dependence of exchange bias and coercivity ferromagnetic layer and antiferromagnetic gain layer is discussed.

4. The remanence, coercivity energy product decrease with deteriorated grain alignment.

5. At present, most coercivity measurement devices designed by national or international criterion are used for soft magnetic samples.

6. The higher the intrinsic coercivity H cj , the lower the coefficient of the intrinsic coercivity and the lower the irreversible loss of flux.

7. High permeability, low coercivity and low loss can improve the efficiency of power supply.

8. With increasing annealing temperature, the coercivity Hc decreases and the saturation magnetization Ms increases.

9. The magnetic saturation induction and magnetic coercivity can be the measurement of content of carbon and grain size of WC, respectively.

10. The coercivity of cobalt ferrite thin film is one of the most important properties in applications for high density magnetic recording and magneto-optical recording.

11. The coercivity was reduced by 33% using a 2 minutes RIE process, which had a negligible effect on the MR.

12. Sm_2Co_(17) magnets are made up of 2: 17-type phase and 1: 5-type phase and affect the coercivity.

13. In comparison with undoped barium ferrite, saturation magnetization of samples increased and intrinsic coercivity decreased remarkably.

14. The results indicate that as the magnetizing field increases, both the coercivity and remanence increase sharply up to a certain high field and then slowly increase to a saturated value.

15. Stray field, caused by different pinned layer, results in observantly different bias field and coercivity of free layer.

16. The variation of effective anisotropy was basically the same as that of coercivity.

17. Before regular use of electro-magnet of the magnetic material Alnico, aluminum nickel and cobalt is very low coercivity, high magnetic permeability, however, it is easy to demagnetization.

18. The results of the experiments show that aging treatment has no influence on sample's density and remanence, but has great influence on intrinsic coercivity and magnetic energy products.

19. According to the exchange-coupling theory, nanocomposite permanent material can have the high remanence of soft phase and the high coercivity of hard phase at the same time.

20. The fundamental characteristics of the latter, including the current research of the remanence and coercivity are analyzed and discussed.

21. Among all MAMs, metallic magnetic materials are especially focused on due to high saturation magnetization, high permeability, high Curie temperature and low coercivity.

22. These can satisfy the request of magneto-optical recording media about high coercivity and big kerr rotation.

23. Nanocomposite permanent magnet exhibits excellent magnetic properties combining high coercivity of permanent magnetic phase with high saturation magnetization of soft magnetic phase.

24. Metal magnetic powder with fine particles and relative higher coercivity and remanence are ideal materials for high density magnetic recording.

25. Transverse rupture strength, Rockwell A hardness,[http://] magnetic saturation induction and magnetic coercivity of samples sintered in vacuum or by sinter-HIP were measured.

26. After the heat treatment, the lattice constants, the size and saturation magnetization of the particles increase, and the coercivity first increases and then decreases.

27. Scientists have been devoting to enhance the density of magnetic recording media for years. Magnetic materials are expected to be with high coercivity and high saturation magnetization.

28. The size of the particles prepared by sol-gel method is little bigger than critical dimension and accordingly these samples have relatively high coercivity.