1. To ensure low leakage current and low dielectric absorption, the feed back capacitor should be made of a suitable dielectric material such as poly styrene, polypropylene, or Teflon.

2. This paper analyzes the reason producing surface leakage current of high resistivity detector, and adopts guard ring to reduce the leakage current.

3. This system includes the leakage current detect unit and the remote computer control and administer center.

4. The leakage current shall be less than 0.75m A for class II when power supply is operated maximum input voltage and maximum load.

5. Leakage current during the time between the chip is electrified but not programmed is decreased mostly, gated clock and input pull-down are used to eliminate swing power of unused LC.

6. After the soft breakdown, the leakage current at the low electric field increases irregularly.

7. Gas-filled relays also provide low, stable leakage current in applications sensitive to current fluctuations especially across open contact sets over long periods of time.

8. However, the increment of gate leakage current increases abruptly after the soft breakdown.

9. Using the leakage current of silicon planar diode with low concentration of metallic contamination as index, we investigated the influence of heat treatment on gettering efficiency of the cavity.

10. The leakage current of the dielectric isolation is very small.

11. Electrical characteristics: capacitance, dielectric loss tangent, leakage current and etc. , which are specified in catalogue or alternate product specification.

12. Low leakage current, low dissipation factor and small body. Used in flesh lamp circuits in camera.

13. FN tunneling and hot hole (HH) stress induced leakage current (SILC) transient characteristics in thin gate oxide are investigated.

14. When measuring the leakage current with this setup, the voltage bias is applied to all the diodes simultaneously through the normally closed contact of each relay.

15. However, offset current and leakage current are the types of interference most frequently encountered and are explained further at the end of this section.

16. Since the leakage current through the zener diodes results in a voltage drop across the resistor, low leakage zener devices are desirable.

17. It is proved that the fundamental harmonic wave of resistive component in leakage current is the main cause of heat damages of MOA.

18. This paper suggests a new method to measure the resistance leakage current wirelessly for metal - oxide arrester.

19. When the diode is reverse biased, only a negligibly small leakage current flows through the device until the reverse breakdown voltage is reached.

20. An effective way to reduce the leakage power is by means of multithreshold CMOS technique, which can restrain the leakage current by adding a MOS transistor to low threshold circuit.

21. In addition, an expression to show the relation between thermal drift of the offset and the reverse leakage current is presented, which is different from the traditional one.

22. The 1N3595 diode is a good choice for this function because it has low leakage current, typically less than 1pA, even with a forward bias of 1mV.

23. Further thinning of SiON would create unacceptably high gate leakage current and reduce device reliability.

24. The two tests susceptible to junction heating are the forward voltage and leakage current tests.

25. Some failures of 3DK9 switch transistors with higher surface leakage current were analyzed.

26. The electrolytic capacitor anode of Titanium suboxide concerned in this paper have the advantage of high capacity, little leakage current[http://], resourceful and low cost.

27. When testing diodes , the electrical parameters measured include the forward voltage, the reverse breakdown voltage, and the leakage current.

28. The primary performance degradation of SOI device in the total dose irradiation is the back-channel leakage current caused by gate threshold voltage shift.

29. The novel LDMOSFET did not degrade the advantage of SOI structure's low leakage current and parasitic capacitance, which also suppressed the self-heating effects and floating body effects.

30. For phlto - flash, Lug type, Low loss factor and low leakage current.

31. Secondly, the transient characteristics of FN tunneling and hot hole (HH) stress induced leakage current (SILC) in ultra-thin gate oxide are investigated respectively in this dissertation.

32. Finally, our simulation result shows that conventional SOI SBSD-MOSFET can effectively suppress thermionic emission leakage current, but it still can not suppress tunneling leakage current.

33. For photoflash, lug type, low loss factor and low leakage current.

34. This paper expounds the mechanism of insulators contamination flashover and the principle of leakage current monitor.

35. The direct-current leakage test is implemented by using the microampere shielded in low-voltage, and the leakage current increasing of generator stator winding abnormally is detected.

36. Leakage Current Detector Interrupter. · Arc Fault Circuit Interrupter. · Ground Fault Circuit Interrupter.

37. The contamination condition of high voltage insulators is usually estimated by detecting the root mean square (r. m. s. ) of surface leakage current via online monitoring system.

38. The SourceMeter instrument first performs the necessary DC tests, such as forward voltage, reverse breakdown voltage, and leakage current.

39. Various MOSFET tests require making low current measurements. Some of these tests include gate leakage, leakage current vs. temperature, substrate to-drain leakage, and sub-threshold current.

40. The base current and the junction leakage current increase, while the collector current and the breakdown voltage decrease for SiGe HBTs after radiation.

41. However, investigation shows that the leakage current is affected not only by the surface contamination of insulator but also by the environmental factors such as temperature, humidity, and so on.

42. When testing diodes, the electric cal parameters measured include the forward voltage, the reverse breakdown voltage , and the leakage current.

43. The offset thermal drift of pressure sensor is influenced by piezoresistor mismatch and its leakage current in practical applications.

44. The result indicated that the leakage current have been reduced 0.5 1 order by guard ring.

45. For tunable microwave device applications, the PST and BST thin films should own high tunability, low dielectric loss, low leakage current and smooth film surface, etc.

46. The insulation could be characterized by measuring the leakage current of bushing.

47. The grain sizes have effects on the fineness of thick films, ferroelectric properties, and leakage current density.

48. The reverse characteristic is similar to that of the silicon diode, as it draws only a small leakage current when negative anode-to-cathode voltage is applied.

49. For photoflash, lug type, miniaturized(), low leakage current reduces battery consumption.

50. Leakage current is very low after, subjected to high temperature , no-load condition or after lengthily storage period's normal.

51. With leakage current little indication undertakes deciding for the standard, that down-lead that with black list the pen contacts is to electroanalysis of capacitor carrying.