1. An adiabatic wall must be able to block radiation.

2. We could do an adiabatic process.

3. The bin walls are adiabatic.

4. Subsequently adiabatic condition about two states system is obtained.

5. Such reactions are called non - adiabatic.

5. is a sentence dictionary, on which you can find excellent sentences for a large number of words.

6. Be careful. Suppose we are doing an adiabatic process.

7. This is an adiabatic process.

8. Adiabatic combustion temperature at various oxidizer mass flow rates and grain length is obtained by thermodynamic calculation and has a maximum as oxidizer mass flow rate increases .

9. These results indicate that the newly developed automatic adiabatic calorimeter has the ability to imolement the high precision calorimetric measurements.

10. Its adiabatic temperature rise can make materials reach the degree of serious soften and fail.

11. The calculation of adiabatic flash was simplified with a heat analysis.

12. Adiabatic temperature rise is measured by concrete adiabatic temperature measuring device.

13. Generally(), insulation blankets consisting of aerogel adiabatic materials or 9% nickel steel may be selected for fabricating low temperature subsea LNG pipeline.

14. TEM observation showed that the center of the adiabatic shear band (ASB) was composed of recrystallized nano-grains ( about 30-70 nm in diameter).

15. Of course, the moist adiabatic process and the pseudo adiabatic process in classical atmosphere thermodynamics are also its special instance.

16. The adiabatic capillary tube model was established based on energy conservation , mass conservation and momentum conservation equations.

17. This modle is made up of two polytropic and nwo adiabatic branches and worked between two finit heat reservoirs.

18. The microstructure of Inconel 718 chip is continuous under low cutting speed and serrated under high cutting speed because of adiabatic shearing.

19. The catalytic behaviors for liquid-phase transalkylation were compared between 3994 and 3984 catalyst in an adiabatic fixed-flow bed.

20. Author has discovered the accumulating effect of air subjected adiabatic compression which is under the flying plate at atmospherical pressure.

21. Based on the working principle, counter structure and Clocked Transmission Gate Adiabatic Logic circuits, a design scheme of decimal counter with reset is proposed.

22. First, the nature of dehydrogenation of ethylbenzene to styrene was studied in an experilmen - tal adiabatic reactor.

23. In the past twenty years, owing to the discovery of Berry's geometrical phase in 1984 , a lot of efforts have been made on quantal adiabatic theorem and geometrical phase .

24. Based on a thermal model of monopropellant thrust chamber system including its components such as adiabatic frame, catalyst bed, nozzle etc.

25. This paper presents a simple method for measuring gas adiabatic constant by use of simple harmonic oscillation .

26. According to the equilibrium composition propane dehydrogenation, we simulate the adiabatic combustion pressure rise at different industrial reaction temperature under different oxygen concentration.

27. Introduces and analyses the calculating software of steam parameters and enthalpy drop of adiabatic expansion.

28. Instead of the complicated mathematical model, the correlation method could be used to predict the choked flow rate through adiabatic capillary tube.

29. This expansion takes energy from the air, resulting in temperature reduction, a process known as adiabatic cooling.

30. It is found that for a properly chosen zeroth order Hamiltonian, under adiabatic approximation, the result of quantization for both the chaotic state and the regular state has the similar precision.

31. The limit on thermodynamics for gas cooling is the adiabatic saturation temperatures.

32. OK, so now we're going to do the same kind of experiment, but irreversibly. An irreversible adiabatic.

33. Based on certain assumptions, three different definitions of efficiency were proposed, that is adiabatic efficiency, diabatic efficiency and heat efficiency.

34. We derive formulae of how to calculate the geometric and dynamic phases for spin-1 particle in adiabatic and nonadiabatic evolutions, and calculate the phases by using these formulae.

35. A two-fluid model(TFM) for two-phase flow of refrigerant in adiabatic capillary tube was developed. Both inter-phase velocity slip and temperature slip are taken into account in the model.

35. is a sentence dictionary, on which you can find excellent sentences for a large number of words.

36. There are two type of adiabatic shear bands theand the transformed bands.

37. According to the engineering thermodynamic theory, the inflating work and ebulliency work exerted by the materials composed of liquid, vapour and gas during the adiabatic process are calculated.

38. Based on adiabatic passage, transfers of an unknown state of one atom, entangled state of two-atom and GHZ state are realized, where only one vacuum-cavity is needed.

39. Assume that atmosphere is made of diatom ideal gas in adiabatic equilibrium.

40. In this paper, the internal energy and heat of the polytropic process, the adiabatic process and the isothermal processes of the varying mass system are discussed.

41. The temperature fields of adiabatic wall and conductive wall were measured.

42. Besides, we find a new geometric quantity in adiabatic process, and we made some further researches on it.

43. Adiabatic shear instability will take place when the normal component of particle velocity excesses critical value.

44. Energy recovery threshold logic (ERTL) is proposed, which combines threshold logic with adiabatic approach.

45. This article suggests that it is incorrect to equate Adiabatic Approximation with Slaving Principle in Synergetics, as the former is a special case of the later.

46. With the rapid development of high-rise buildings in cities, people bring forward that building glass should satisfy with the fire-resistant and adiabatic criterion.

47. It is also feasible to adopt the adiabatic fixed-bed reactor and the techniques of multistage reactions and interstage cooling.

48. The stability of a liquid helium free superconducting magnet could be analyzed using the adiabatic stability criterion because there is no cryogen in the system.

49. Avoid conditions that can result in high temperatures, such as adiabatic compression, from the rapid pressurization of a system.

50. Flue gas out-let temperature approcich to adiabatic saturation temperature and tangential velocity of spray whool etc.

51. While the equivalent strain rate is high, this influence is of importance and the compression process can be approximately considered as an adiabatic process.

52. For a stationary, adiabatic flow the specific energy E, specific angular momentum L and mass accretion rate M are constant in space.

53. The results show following conclusions. The adiabatic temperature influences calculation error more than heat transfer coefficient when the boundary temperature difference is low.

54. While scrubbing process the flue gas is saturated with water and cooled down to its adiabatic saturation temperature.

55. Otherwise, the value R of the gas constant and value K of adiabatic exponent can not be determined and the subsequent calculation also can not be conducted.

56. In this paper, the method of numerical calculation of the adiabatic electron gun used in gyrotron is discussed.

57. By using the kinetic theory, the microscopic mould of the perfect gas adiabatic process is built, the adiabatic process equation is calculated by Maxwell Velocity Distribution.

58. A two - fluid model ( TFM ) for two phase flow of refrigerant in adiabatic capillary tube was developed.

59. The technology of average qualitative data is characteristic, if wear, intensity, hardness, heat preservation, adiabatic, wearability, bibulous rate, moisture content, hole is led, wait a moment.

60. The polyurethane foam has found more and more extensive application because of its excellent adiabatic performance.

61. The three - dimensional Boussinesq equations with no - viscosity and adiabatic under the hydrostatic equilibrium are studied.

62. Although the critical two-phase flow of refrigerant through adiabatic capillary tube is nonlinear, its mass flow characteristics under some typical operating conditions show good linearity.

63. In some delivery systems, NF 3 may be subjected to adiabatic compression.

64. The research of ethylbenzene dehydrogenation kinetics has been carried out in an experimental adiabatic reactor.

65. This method can be used to pipes of two - phase adiabatic flow.

65. try its best to collect and build good sentences.

66. And you know, you could have a reversible engine with lots and lots of steps, but you could always break them down into some sequence of adiabatic and isothermal steps.

67. It is discussed that adiabatic material, as well as ratio of height and width effected solidification, shrinkage cavity and shrinkage porosity.

68. The fluctuating amplitude of mass flow rates of branch pipeline outlets with hot wall boundary is bigger than that with adiabatic wall boundary, and the maximal fluctuating amplitude goes up to 2.16%.

69. This kind of expansion, made without adding heat, is called an adiabatic expansion.

70. Usually, mode coupling between normal modes is solved by two-way coupling mode, one-way coupling mode and adiabatic mode theories.

71. The remainder of the power stroke is an adiabatic expansion.

72. Time - dependent Perturbation Theory. Transition probability. Adiabatic theorem revisited. Sinusoidal perturbations.

73. On hd diagram, users can analyze and calculate some typical thermal process of humid air in wood industry such as heating process, add-wet process, adiabatic process and mixing process etc.

74. This paper discusses the finite time availability of ideal gas system in constant volume process, constant pressure process, isothermal process and adiabatic process.

75. The change adiabatic temperature was small during coupling isomerization with aromatization of hexene - 1 , because both re.

76. In an adiabatic process no heat is allowed to enter or leave the system.

77. In an adiabatic system, this heat release serves to increase the chamber temperature.

78. Based on the adiabatic compression theory, adiabatic pulse compression using the nonlinearity - increasing fiber is suggested and investigated.

79. The diameter of a fixed-bed adiabatic reactor, height of catalyst bed and catalyst loading were calculated by using Runge-Kutta numerical solution method.

80. Has the advantages, adiabatic, fire prevention, high temperature resistance, ageing resistance, bibulous rate is lower notable features.

81. After introducing an adiabatic or thermo-equilibrium assumption between phases, the expression reduces to a particular expression for the complete or partial equilibrium speed of sound.

82. Energy content of fuel is obtained in most cases in an adiabatic, constant volume bomb calorimeter.

83. By quantum jump method, we find that the corrections to its phase for the no-jump trajectory are different when considering adiabatic and nonadiabatic evolutions.

84. For this project accept the default Adiabatic wall feature denoting that all the model walls are heat-insulated. Click Next.

85. Middle layer- adiabatic board made by hi-temperature ceramic fiber plus thermally insulated bricks as heat barrier .

86. The mass flow rate varies with the inner diameter and the length of adiabatic capillary tubes, the degree of subcooling and the condensing temperature were investigated.

87. Excellent adiabatic design reduces heat loss and temperature recovering time greatly, ensures no pollution in loading area, and staff can be far away from metaphosphoric acid harm.

88. Taking advantage of the adiabatic passage, this kind of quantum logic gate is robust against moderate fluctuations of experimental parameters.

89. This paper discusses the principle of relative adiabatic computing of single channel transmission gate from the idea of finite dynamic power dissipation.

90. The stochastic resonance(SR)in an optical bistable system under the simultaneous action of multiplicative and additive noises and periodic signal is studied using the adiabatic approximation theory.

91. Under the adiabatic condition, adiabatic compression heating influences the microbial inactivation.

92. Adiabatic demagnetization is used.

93. A suitable definition for adiabatic process equation and study on the ideal gas adiabatic process in detail provide more clues for practical gas process.

94. Furthermore, this method can obtain both 3D flow field characteristics and the temperature field characteristics under adiabatic wall condition.

95. The paper reports a numerical study of velocity, temperature and cooling efficiency distributions of an adiabatic wall with film cooling.