1. Hence the voltage drop across R5 will be in the range 0.4V to 1.4V.

2. Note the polarity of the voltage drop across R.

3. As its resistance increases, its voltage drop increases and, though small, can be measured without difficulty.

4. The forward voltage drop in the on-state is only a few volts(typically 1 to 3 V depending on the device blocking voltage rating).

5. The local action rate is the ratio of voltage drop and the total voltage of cell.

6. With the presence of electrode voltage drop and cur -rent leakage, applying the method of equivalent electrical conductivities the variations of the above parameters are studied.

7. Tells electrical voltage drop over distance, both for AWG and metric cables.

8. The value of voltage drop and loss of variation of inductancedepend upon load loop inductance in superconducting film.

9. The wear mass loss contact voltage drop of traditional electric brush are both larger than brush.

10. V 、 and Vare the voltage drop of the DUT due to the applied current.

11. There is also considerable voltage drop in the consumer's internal wiring.

12. The author evaluated the output voltage drop owing to the commutative process and armature reaction in detail by means of the analysis of the existent system and the dynamic simulation experiments.

13. Electrode voltage drop and current leakage have considerable influence on the performance of the generators, so the reduction of them is important.

14. It also makes sure that the extra load of the solenoid valve does not cause problems due to sudden voltage drops.

15. The Source - Measure Unit can also test other diode parameters, including forward voltage drop and breakdown voltage.

16. Simulation results based on this model show that the total amount of impurity in the buffer layer or transparent anode is the key to determine the on-state voltage drop of GCT device.

16. Wish you will love and make progress everyday!

17. Describing the specialities of the starting motor brushes are of short-time duty system , big current density and the contact voltage drop must be as small as possible.

18. Simulation results show that the doping profile and width of P base region are important to the on-state voltage drop of Gate Controlled Thyristor.

19. The optimal design of large transformers with combinatorial optimization and with the reactance voltage drop as the constraint is described.

20. The importance of X - ray inspection, withstanding voltage test and voltage drop control were emphasized.

21. The voltage regulation has only 1% deviation and the voltage drop is only 4.7% of the nominal output voltage when the load power is from 20% to 100%.

22. Based on the model, the variations of the electrical parameters such as the potential barrier, the anode junction voltage drop, and the current amplification factor are studied and discussed.

23. The effect on the generator excitation magnetic field is different when the capacity and power factor of load are different, and the effect on the internal impedance voltage drop is different, too.

24. In this paper, the mechanism of harmonic increments caused by device characteristics are analyzed in detail, and the compensation algorithm of a forward voltage drop is proposed.

25. In this paper, integral diode solar cell array for space use are presented. The forward voltage drop of the diode is related to its area and the rule of thumb equations are- given.

26. To mea - sure the forward voltage, apply the specified current, then measure the resulting voltage drop.

27. Since the leakage current through the zener diodes results in a voltage drop across the resistor, low leakage zener devices are desirable.

28. Measure the reverse breakdown voltage by sourcing a specified re verse current bias, then measuring the voltage drop across the diode.

29. The major advantage with these types of switches is that the voltage drop across it during conducting and non-conducting states, is ideally zero.

30. However, accompanying beneficial reduction in switching speed there is a deleterious increase in forward voltage drop.

31. Refers to the electrical generator rated voltage at rated operation conditions, the terminal voltage after the rectifier and the deduction of the DC link output voltage drop.

32. The on-site test results indicate that energy meter's neutral point virtual connection has a great effect on PT secondary voltage drop.

33. The PT secondary loop voltage drop equals to the product of the PT secondary loop impedance and the loop current.

34. This article describes the design principle of the device and its parts, analyses the safe current-carrying capacity, voltage drop, sliding contact and are extinction performances of the device.

35. It has been proved that the value of the voltage drop can be achieved through the extrapolation of the forward current voltage curve when the current through the Schottky barrier diode reach 40A.

36. In the experiments , the relationships between impedance and time , voltage drop and time , were obtained.

37. Since voltage drop is prevented, voltage required for obtaining a necessary charge can be lowered./voltage drop.html

38. The PT secondary loop voltage drop is a changing amount and has the characteristics of indirection and certain randomness.

39. It's just that a buried zener is even better, if you can afford the higher voltage drop .

40. Forward Voltage Drop Power Loss, High Efficiency, High Surge Current Capability.

41. This paper analyses the blocking voltage, forward voltage drop, photoresist mask design and gate-triggering and dynamic characteristics of high-power thyristors.

42. Because of the low test current level used, a very sensitive voltmeter is required to measure the voltage drop, which is usually in the microvolt range.

43. This reduction is caused by the internal resistance (RM), which creates an additional voltage drop called the voltage burden (VB).

44. The system includes a Model 6220 Current Source to supply the current through the sample and a Model 2182A Nanovoltmeter to measure the resulting voltage drop.

45. The mechanism of harmonic increments caused by power device forward voltage drop and DC-link capacity voltage variety are analyzed in detail, and the compensation algorithm are proposed.

46. When the test current is applied, the instrument will indicate the resulting voltage drop.

47. Application of PC based instrument for ground impedance measurement can overcome the shortcomings in traditional voltage drop measurements.

48. Thermal losses are significant due to the minimum SCR on state voltage drop.

49. A new method for testing the load current and realizing the current limited control through testing the saturable voltage drop of MOSFET is introduced.