1. WITH THE DRB IN OHMMETER MODE , PROBE THE SYSTEM RELAY OUTPUT CIRCUIT.

2. Using an ohmmeter, check the resistance between the brush lead and the starter yoke.

3. Using an ohmmeter check the resistance between terminals 50 and C.

4. Using an ohmmeter check the resistance between the commutator and the armature core.

4. try its best to gather and make good sentences.

5. Making transmission projection experimental realia of Ohmmeter is convenient for teaching Ohm-meter measurement principle with the aid of projector.

6. Using an ohmmeter check the resistance between the segments of the commutator.

7. For most applications, the micro - ohmmeter or DMM is sufficient for contact resistance measurements.

8. Using an Ohmmeter, connect a lead across the two terminals.

9. The ohmmeter uses an internal current source and electrometer voltmeter to make the measurement.

10. Although not a precision instrument, the ohmmeter is a useful device for rapid measurement of resistance.

11. WITH THE DRB IN OHMMETER MODE, MEASURE THE GROUND CIRCUIT.

12. Using an ohmmeter check the resistance between terminal C and the field coil brush lead.

13. When using the electrometer ohmmeter, measurement accuracy can be affected by a variety of factors.

14. WITH THE DRB IN OHMMETER MODE, PROBE THE RR CKT.

15. USING AN OHMMETER MEASURE THE GROUND CIRCUIT AT KEY - IN IGN SWITCH CONN.

16. Attach test leads to pins 5 and 6 and note ohmmeter reading.

17. Attach test leads to pins 1 and 2 and note ohmmeter reading.

18. This paper introduces a kind of digital micro - ohmmeter, its characteristic and the use method.

19. The most basic instruments include an ammeter, voltmeter, and ohmmeter . 2.

20. Figure 1 - 18 shows the basic configuration of an alternative form of electrometer ohmmeter.

21. These measurements can be made with either a micro - ohmmeter or a nanovoltmeter with a current source.