(1) Dead center as the shot clock went to zero.

(2) The arrow hit the target dead center.

(3) Turn the piston to the top dead center.

(4) The tribune seats were exquisite - dead center of the track, just meters away from the asphalt.

(5) When the piston reaches the top dead center, the temperature of oil film decreases from the top part of piston skirt to the bottom part of piston skirt.

(6) The top dead center is confirmed using cylinder compressing line method and magnetoelectric method and the position of top dead center is validated with variety index method.

(7) When obtain piston position signal from Crankshaft, Top Dead Center Sensor and Crankshaft Position Sensor tend to be integrative in structure.

(8) The top dead center (TDC) phase has a great effect on the result in the combustion analysis of internal combustion engines, so it is very important to obtain the dynamic TDC phase correctly.

(9) The cycle begins at top dead center (TDC), when the piston is furthest away from the axis of the crankshaft.

(10) The bottom dead center profile of high speed press in idling time has been promulgated in the text by comparing with the import equipment.

(11) Further, the piston is operated at the top dead center position and in the resonance state under all load conditions, thereby further increasing operation frequency.

(12) It's for detection of engine speed, piston top dead center position, signal ignition and injection control in top dead center of each piston.

(13) Two TDC ( Top Dead Center ) sensors are mounted at the rear of the single camshaft.

(14) The enlarged Spyderco Round Hole is dead center on the blade when closed and perfectly off-centered when open, positioning the thumb for flowing one-hand operation, justifying the name Balance.

(15) The dead center , being a stationary bearing point, must be lubricated.

(16) He points to a spot of oil in the water and hurls his harpoon and strikes the spot dead center.

(17) An unabashed king-size bed made up with a flowered bedspread stands in the dead center of the room.

(18) Moreover, the ball plungers (6) are positioned near the piston top dead center, at which the piston ring is positioned.

(19) For a CNG engine, the cylinder pressure signal, gear pulse signal and top dead center pulse signal were simultaneously collected.

(20) Fred fired without thinking, a full auto burst , dead center of mass.

(21) This sensor can also indicate which cylinder will reach to tope dead center, so it' also called cylinder indication sensor.

(22) It is very important to identify the engine dynamic top dead center phase in the combusting analysis of IC engine.

(23) In this paper, the cylinder pressure signal, fluted disc impulse signal and top dead center impulse signal are sampled synchronously.

(24) On the upward piston strokes, the exhaust valves are open until the piston is nearly at TDC (top dead center).

(25) When this indentation is aligned with a special hole provided in the bell housing, the piston is at top dead center (TDC) or indicates the start of fuel injection into the first cylinder.

(26) The stroke is the distance the piston travels from BDC (Bottom dead center) to TDC(top dead center).

(27) The results of calculating and experimenting show that the first and largest slap of impact between the piston and the liner occurs around the top dead center from the nonthrust to the thrust face.

(28) But this time there is a stop block valve to prevent valve flap over top dead center and open.

(29) The Bore is the diameter of the cylinder. The stroke is the distance the piston travels from BDC (Bottom dead center ) to TDC(top dead center). The Bore is always mentioned first.