1. Remove the water pump from cylinder block.

2. The root causes of motorcycle cylinder block wearing are temperature variation and presence of hard abrasive dust.

3. A entity model for the cylinder block of YC6108 diesel engine has been constricted and the modal analysis been implemented.

4. In this paper, heat transfer boundary condition of cylinder block water jacket was determined by means of liquid-solid coupled method.

5. The metallurgical quality of cylinder block head of D 114 diesel engine was analyzed.

6. The features of cylinder block and cylinder head core assembly vertical casting process are introduced.

7. The casting reject ratio of cylinder block caused by crankcase core is controlled below 0.25 % at present.

8. Cylinder block is an important part in motorcycle engine. There exists defects by conventional treatment.

9. A entity model for the cylinder block of YC6108 diesel engine has been constructed and the modal analysis been implemented.

9. Wish you can benefit from our online sentence dictionary and make progress day by day!

10. The reasons causing leakage of cylinder block and head were analyzed.

11. Position the cylinder heads onto head gaskets and cylinder block.

12. Like the cylinder block, the head is made from either cast iron or aluminum alloy.

13. This equipment specially used for engine cylinder block and head of water jacket and oil leakage of tao detection.

14. He swung his wooden toolbox into the engine bay and laid it on the cylinder block.

15. Two completely different schemes for cooling water flow are obtained by changing the diesel engine's water flow from the oil condenser to the water jacket of the cylinder block.

16. Some V - type engines have a pump on each cylinder block.

17. This paper The cause of the scab of the inside surface of cylinder block on condition that the resin sand cores are made in cold core box.

18. The coolant then flows through line(3) back to the top center of the cylinder block.

19. According to the DISA Technical Design Standard and our experience, we use chocked-unchocked gating system to design the complex structure and high-strength technical system of QD90 Cylinder Block.

20. The combustion pressure force in the cylinder head bolts is transferred via reinforced sections in the cylinder block walls direct to the main bearings.

21. The crankcase is the lower part of the engine cylinder block.

22. The principles to construct finite element model modal analysis of the cylinder block have been obtained.

23. HINT: Keep the upper bearing and upper thrust washers together with the cylinder block.

24. Tighten the radiator drain cock and ( if removed ), the cylinder block drain - plug.

25. The paper analyzes the design optimization of core box using coated sand in Z8040 hot box core shoot machine to make the cylinder block cores and sprue cores.

26. Dispersed shrinkage is the main reason causing leakage of cylinder block of 4 DA 1.

27. The model was employed to evaluate the equipment usability of an engine cylinder block production line.

28. Based on the dynamical impingement force on the liner, the vibration response of cylinder block resulted from piston slap force was obtained by using finite element method.