1. In this paper, effects of depth of cut and feedrate on mechanical properties of metallic fiber are investigated by spinning bit.

2. Any desired depth of cut can be obtained by the cross feed of the grinding wheel.

3. Depth of cut, d, is the normal distance between the unmachined surface and the machined surface.

4. They provide a constant depth of cut and fewer blade changes.

5. As we can see in that figure, the depth of cut (and consequently the load) gradually increases on the successively engaged cutting edges.

6. The depth of cut is adjusted by the cross feed of the grinding wheel into the workpiece.

7. Besides, if the feed and depth of cut is increased, the lubrication effect will become poor, and the reducing extent of the cutting force will be reduced.

8. This particular model predicts the depth of cut achievable with any given set of process parameters.

9. Using the saw with an excessive depth of cut setting increases loading on the unit and susceptibility to twisting of the blade in the kerf.

10. Cuttings forces increase almost linearly with depth of cut and feed rate.

11. After about an inch I was told to switch off while he checked the angle and depth of cut.

12. A quadratic model of predicting helical milling force was researched. The effects of spindle speed, feed per tooth, and axial and radial depth of cut were analyzed.

13. During a facing operation, feed is provided by the cross slide, whereas the depth of cut is controlled by the carriage or compound rest.

14. The axial feed is provided by the carriage or the compound rest, either manually or automatically, whereas the depth of cut is controlled by the cross slide.

15. The distribution of chip thickness along the cutting edge is modeled as a function of tool inclination angle, nose radius, depth of cut and feed rate.

16. Tangential grinding forces are obtained through monitoring spindle power and the ir variations are studied with process parameters such as depth of cut, feedrate and wheel grit size.

17. Grasping the top, knurled section of the depth adjustment rod (Q), slide it up so that the tab (EE) aligns with the desired depth of cut on the pillar scale (FF).

18. The selection of a suitable feed depends upon many factors, such as the required surface finish, the depth of cut, and the geometry of the tool used.

19. The conditions which have an important influence on metal cutting are work material, cutting tool material, cutting tool geometry, cutting speed, feed rate, depth of cut and cutting fluid used.

19. is a sentence dictionary, on which you can find good sentences for a large number of words.

20. This paper deals with the engagement of gears with circular arc profile in normal plane at the presence of errors on center distance and depth of cut.

21. The workpiece is clamped in position, and cutter is located against the setting block, which provides setting or cutter position and depth of cut.