1. Exposure to HVAC control system and control logic.

2. Data abstraction, exception handling, control logic and concurrent processing.

3. And the control logic of FPGA, image access via DMA are analyzed in detail./control logic.html

4. Finally, the controller using the target ratio control logic is designed and the effectiveness is validated.

5. The control logic preventing the compressor from surge was analyzed and improved after the performance curve of compressor in gas turbine booster station was analyzed.

6. It completes the system control software and FPGA control logic design, and achieves the data-processing function of amplitude and phase-frequency testing, parameter storage, calculation of Q-value.

7. After simulation, fuzzy control logic is used in the TCU. By using this approach in the MC9S12DP256, the practicability of fuzzy logic is improved.

8. The system control logic, the address generator and the data bus separator are designed with a complex program logic device (CPLD).

9. The structural design of logic level shift and control logic circuits are dealt with in particular.

10. Buffer register, circular allotter, control logic, positive run and back run control circuits are replaced by computer software.

11. The yaw-rate feedback is taken as the basic control logic for 4WS vehicle, which is easy to use.

12. Three transistor dynamic cells and buffered I/O control logic are used for the device. The control circuit is optimized for Y C separation system.

13. Design electrical lighting and motion control systems, including control logic programming and harness layout.

14. The control logic relation of all the station equipments can be divided into two stages. The bottom is a direct process control stage and the top is a compute supervisory control stage.

15. The step motor controller composed of buffer register, the circular allotter, the control logic, the positive run and back run control circuits is replaced by computer software.

16. A hardware pattern in which diode leads may be inserted to change solid - state control logic.

17. Continuous hot dip galvanizing line a biggish electrical control project which is complex for control logic.

18. To improve data transmission rate of JTAG interface, instruction register and related control logic are redesigned.

19. The programmable controller uses the ladder diagram and auxiliary identifier to realize control logic mainly, it reflects the flexible characteristic of PLC controll outstandingly .

20. This paper introduces the electrical design for the high voltage motor to realize the running of the chipper, the relevant control logic and the control mode for realizing the control logic.

21. In this system, computer software was used to replace stepping motor controller which consisted of buffer, annular allotter , control logic and control doors of clockwise and counterclockwise running.

22. Based on the double parameter logic gate control, a new fuzzy control logic is presented and a two-stage fuzzy logic controller based on wheel angle acceleration is designed.