1) The clusters nucleate exclusively in the hydrocarbon surface contamination.

2) Removal of surface contamination and corrosion products by use of air and mechanical abrasives (also referred to as sand or shot blasting).

3) The smear method for monitoring tritium surface contamination is described.

4) This paper introduces the circuit of a surface contamination survey meter based on MSP430F149 in detail, and provide the flow chart of some program.

5) Cleaning can eliminate surface contamination of membrane and recover the water flux.

6) The possibility of surface contamination moving inside silastic is studied via energy spectrum analysis.

7) The presence of exogenous surface contamination, including dirt, grease, free iron from contact with steel tooling, and so forth, may interfere with the formation of the passive film.

8) The results showed the surface contamination produced in sample preparation and treatment can be eliminated if the sample was sputtered for enough time.

9) There is no surface contamination, but there are still many regulatory requirements such as signage, inspections,(http:///surface contamination.html) and maintenance for these units.

10) It can measure the work function of the surface, the film thickness, the surface contamination and the material defect.

11) A three layer of aluminum exposed to atmosphere is identified: the aluminum and its native oxide, the corrosion layer atop oxide aluminum, and a surface contamination layer.

12) The effects of gas flow rate, chamber pressure, and rf(radio frequency)plasma power on the etch rate were investigated and the surface contamination due to RIE was examined.

13) After dehairing, the carcass is usually exposed to open gas flames to remove remaining hair and reduce surface contamination.

14) The application of this system in Liaohe oil province shows that, oil production rate has increased, surface contamination has reduced, and environment is protected .

15) However, investigation shows that the leakage current is affected not only by the surface contamination of insulator but also by the environmental factors such as temperature, humidity, and so on.

16) After a few passes with the clay bar, rub your hand over the area to feel that surface contamination is removed.

17) Adopting optimized machining parameters of Laser-Microjet, higher cutting speed, higher surface quality, no surface contamination, and no oxidation is visible.

18) Compared with the prior hygrometer with a moisture sensitive sensor, the invention solves the problem of short service life of the sensor as no failure resulting from the surface contamination occurs.