1. Each interaction produces an energy loss and deflection.

2. According to the energy loss of every part of screw pump well, established system efficiency analysis model for the well.

3. Seismic wave attenuation in rock means wave energy loss in rock.

4. Energy loss of combustion system on regenerative heating furnace is analyzed, improved program is proposed.

5. In terms of the effective damping matrix, the energy loss and specific damping of the laminate.

6. The energy loss of the impact mechanism of hydraulic rock drill greatly affects drilling efficiency when it operates.

7. Leading energy loss of the flow valve in hydraulic rock drill was analyzed and its formula was presented.

8. The calculation results of the energy loss function and effective electronic density indicate that there are only few electrons taking part in the interband transition.

9. According to the high energy loss of factory lighting, the artical presents implementing power conservation reform by SLC intellective lighting control.

10. However, the energy loss in model of LQS energy loss with effect of segmental distributed function is overestimated, hence, the results is decided difference with the experimental data.

11. That excess voltage is an energy loss, meaning it takes far more energy to make the CO than it can store in its chemical bonds.

12. In terms of the effective damping matrix, the energy loss and specific damping of the laminate can be calculated by using the effective stress and effective strain.

13. To reduce energy loss, the operation optimization and project setting of oil transferring system is necessary.

14. Matching one discreteness with another Bohr supposed that the energy loss was radiated as a single photon.

14. try its best to collect and build good sentences.

15. The process of reflection does not in itself involve any energy loss.

16. Based on the optimized discharge curve computed from the optimal dispatching of one flood, an energy loss function and a new method, the spillway dynamic tracking (SDT), are established.

17. At the same time broaden the spectrum as result of energy loss fluctuations.

18. In the framework of QED and QCD many theoretical studies focus on radiative energy loss induced by the multiple scattering.

19. This paper introduces the features of MCS E1 electronic overload protection relays, such as phase failure protection, high repeat accuracy, low energy loss, wide current adjustment range and so on.

20. This paper presents an experiment for measuring the acoustic energy loss in the sand bed in water tank.

21. For coordination functions of DCF, EDCA, PCF and HCF, the thesis proposes corresponding methods to reduce overhear, which is the greatest source of energy loss for 802.11PSM.

22. In the thermal medium, the stimulated thermal gluon emission reduces while absorption increases the parton's energy. The net contribution result in a reduction of the parton energy loss.

23. This paper describes the Multiplex TimeConversion ( TDC ) system used in Electron Energy Loss Coincident Spectrometer ( EELCS ).

24. It is interesting to inquire into the exact mechanism of this energy loss.

25. The most affected was secondary flow losses for the energy loss distribution along the blade height, other losses along the distribution was average.

26. Based on quasi-linear model of SR motor, the influences of angle on phase current, output power, energy loss are analyzed. An optimum result of angle is produced in accordance to given target.

27. The tests have shown that the single-base porous propellant deterred by EGDMA have appropriate burning time, low energy loss, and better progressive burning in comparison to the single-base of 15/19.

28. By lagging the hot water tank and pipes you can reduce energy loss.

29. Conductor in the non- uniform magnetic field of mobile or in the time - varying magnetic field, due to eddy current energy loss as a result of the eddy current losses.

30. Coadsorption of CO and K on W (100) was investigated using high resolution electron energy loss spectroscopy (HREELS).

31. And energy loss in hydraulic jump region could be confirmed by water energy equation.

32. Results showed that adding phenolic resin and covering a film on the surface of the powder can prevent the ablation matter spurting out, and reduce the energy loss of condensed phase.

33. The nanowires were analyzed by X-ray diffraction, high resolution electron microscopy (HREM), electron energy loss spectroscopy.

34. The pulse amplitude of narrow band operating approaches to that of broadband operating, it means that, the energy loss caused by narrowing spectrum is only a few.

35. Energy saving technique is mostly achieved by decreasing energy loss and recovering energy in the hydraulic transmission system.

36. This design are the main contents of electric energy loss monitor the design.

37. It cuts down the energy loss, saves the construction area and enhances the design freedom.

38. The work of agencies to rely on speed and for adjusting the pump or motor variables agencies to achieve, to avoid the open loop system for the process are the hydraulic impact and energy loss.

39. The transient analysis of energy loss braking operation process of six - phase asynchronous motors was presented.

40. Energy loss rate is a comprehensive technique - economical target reflecting the management level of electrical power sys - term.

41. Conventional building insulation system can effectively reduce the energy loss from the interior in winter.

42. The energy loss, combined with angular - momentum redistribution, causes a dense ring system to flatten.

43. The energy loss of the gliding irrotational wave pair is made up by the longitudinal wave beam.

44. This article analyses the electric energy loss of adjusting the line current by stages, which has a bigger wave motion when the anode effect happens-a phenomenon peculiar to aiu-minium reduction.

45. Wave resonance and energy loss of inlet pipe were analyzed first and one dimension numerical simulation of unsteady flow was studied.

46. Decay curves metastable fragment ions is also obtained by means of ion energy loss scans spectroscopy.

47. High rigidity and low energy loss increase security of user. As simplified design saves cost and maintains easily. It's the most popular model for material testing machine.

48. When the edge number of characteristic geometry tends towards infinitude, movement of scroll compressor tends to be steadiest and vibration and energy loss decrease least.