1. He quenched the fire with water.

2. Hot steel is quenched to harden it.

3. She quenched her thirst with a glass of Coke.

4. Her letter quenched his hope.

5. The flames were quenched by heavy rain.

6. The large fire quenched at last.

7. Her thirst for knowledge will never be quenched.

8. The blaze was quenched by the brave firemen.

9. I quenched my thirst with a glass of cold beer.

10. He quenched his thirst with a long drink of cold water.

11. This has to be quenched by detachment and renunciation.

12. A great thirst is a great joy when quenched in time. Edward Abbey 

13. They had been desires to be quenched, as he had quenched other desires over the years.

13. is a sentence dictionary, on which you can find good sentences for a large number of words.

14. I quenched the candle flame with my fingers and slid into the bed chamber.

15. Some little flames may be individually quenched, but there is a certain pattern to them.

16. Samples from the reaction mixture are removed and quenched by running into ice cold water.

17. Mr. Roosevelt's reply quenched my last hopes.

18. One more ray of hope had been quenched.

19. The fire was quenched with a bucket of water.

20. The technology of traditional quenched and tempered medium carbon steel sliding yoke is very complicated and it has high rejection rate too.

21. The V2O5 sol was prepared with V2O5 melt quenched, and PEO-V2O5 xerogel nanocomposite films were obtained.

22. The good service results were achieved using laser quenched roughing roll in practical production.

23. The carbon tool steel was quenched into the different concentration of calcium chloride watery solution.

24. To quench steel is that hot steel is quenched to harden it.

25. While life as a sailor was harsh, his thirst for the sea was not quenched.

26. Results show that the excited triplet state of ketocon-marin derivatives can be quenched by iodonium salts through the mechanism of electron transfer.

27. It was found that rapid quenching eliminates the secondary phase in the as cast alloy. An amount of amorphous phase is formed in the quenched alloy.

28. Results show that the supersaturated solidification Cr-content increases in the rapidly quenched alloys induced the great increase of vacancy density and production of vacancy plates.

29. These steels are aged hardenable martensitic steels. The superior combination of strength and toughness is achieved through precipitation of fine M_2C alloy carbide by quenched and aged treatment.

30. The result indicates that there was a great deal of lath martensite in the quenched structure.

31. So long Spencer, it was short but hopefully it quenched your Survivor thirst.

32. The quenching mechanism was studied in a quenched dye laser pumped by excimer lasers.

33. Col workingdie steel with high abrasion resistance for general use , Super hardenability and minimal quenched stress.

34. The results show that the fluorescence of BSA was quenched regularly by the pentachlorophenol, the mechanism of the fluorescence quench was investigated.

35. The mechanism of cutting force, cutting temperature and tool wear in the machining of quenched steel and nickel based high temperature alloy with ceramic tools are analyzed in the paper.

36. When such a quenched steel is tempered, structures with mechanical properties intermediate between those of the slowly cooled and the quenched conditions are formed.

37. His unjust unkindness, that in all reason should have quenched her love.

38. The effect of interrupted quenching temperature on the microstructure and mechanical properties of a direct quenched and self tempered martensitic steel has been investigated.

39. Based on the results of laboratory experiment, the technical parameters of laser quenching process were selected. The roughing roll of Wire Rod Mill at Pangang was laser quenched.

40. The superplasticity research was carried out under constant temperature compression deformation for salt-bath cyclic quenched and high frequency hardened T10A steel.

41. The fluorescence of AaH - 1 is quenched by I ~ -, acrylamide and N - bromosuccini - mide ( NBS ).

42. Machine rectangular table guide face and super - audio have been quenched, perishable wear - resistant .

43. The phase transition process of isothermally quenched ductile iron was investigated, the author's opi.

43. try its best to gather and make good sentences.

44. The paper studies the chemical composition of steel for racing bicycle chain and the mechanical properties after being quenched, then the optimum chemical composition of steel is determined.

45. The results show that, in cutting teat, best cutting speed exists for different quenched steel.

46. The evaluation of measuring uncertainty in metallic material Brinell hardness test is studied by testing the hardness of the 45 quenched and tempered steel.

47. The steel should then be reheated to a point above the transformation range of the case and quenched to produce a hard, fine structure.

48. Compared with the as-cast composite and hadfield steel, the water quenched composite possesses great wear-resistant behavior.

49. The utilization of water quenched slag ferromanganese blast furnace is discussed.

50. The grinding force ratio in grind-hardening consists with the grinding force ratio in grinding quenched steel, and is bigger than the grinding force ratio in grinding unquenched steel.

51. The test has been demonstrated that the boron segregation at austenite grain boundaries in quenched steel is a non-equilibrium grain boundary segregation phenomena occurred during cooling.

52. Micron scale spheres may be preserved in quenched volcanic matrix.

53. Study shows that quenched boron eutectic structure possesses the excellent wear abrasion property.

54. The effect of chemical composition on mechanical properties of the austenite - bainite ( is other - tally quenched ) white iron was investigated.

55. The effect of V on nodulizing of carbides was observed in the as-cast, nomalized and oil quenched condition in low Cr white cast iron alloyed with V.

56. The surface of inoculated cast iron HT300 chain wheel is quenched by laser for improving its antiwear property and increasing its surface hardness, therefore prolonging its life.

57. High carbon steel will be gain a more amount of undissolved(remained) carbide and higher hardness when the steel is quenched with austenite of non homogeneous chemical composition.

58. The cutting experiments show that in cutting of quenched steel the tool life of this cutter is longer than that of uncoated cutting tool.

59. The critical properties of a quenched site - correlated percolation system is treated by real - space renormalization group method.

60. The nucleation and growth of dislocation loops and voids in quenched face-centred cubic metals have been studied.

61. Process of desilication under high temperature-magnetic separation was adopted for iron recovery from water quenched slag of copper smelting.

62. The ceramic layer does not crack or flake off when heated to 800℃ and then quenched.

63. High carbon steel blade, cutting edges induction quenched, a lock in the middle part Dip - ped handle.

64. The stability of up - quenched Cu - 25 . 0 Zn - 4.20 Al ( wt . % ) alloy has been studied by positron annihilation and X - ray diffraction.

65. It can be quenched in a controlled atmosphere, thin carburizing, carbonitriding heat treatment process.

66. The structure, wear resistance and wear mechanism of laser quenched layer on the groove surface of the piston head were studied in this paper.

67. However, brine or water quenching is capable of rapidly bringing the surface of the quenched part to its own temperature and maintaining it at or close to this temperature.

68. An analytical function for describing hardness distribution in round section of quenched steel, known as U-curve, has been established.

69. Carbon tool steel for small production to be quenched in oil, easy to heat - treat.

70. Glass was heated to its softening point and reshaped in mold under its gravity in heating furnace, then was sharp quenched by cold blast immediately.

71. The results show that the properties of the slak quenched rails are matchable or superior to that of the imported rails.

71. Wish you can benefit from our online sentence dictionary and make progress day by day!

72. Grind - hardening of non - quenched steel was performed with creep feed grinding mode and different cooling conditions. Microstructure and properties of the surface hardened layer were compared.

73. Although the present study limits to two-passes grinding, the forming mechanism of the hardened layer is applicable to grind-hardening of multi-passes or quenched steel.

74. The reasons of causing the surface roughness of skived gear quenched and the relevant factors influencing on it are analysed in theory and practice, and the experimental formula isestabblished.

75. Following the method outlined above will produce a fine-grained, fully recrystallized, press quenched product that demonstrates good strength and elongation.

76. It has been demonstrated that the boron segregation at austenite grain boundaries in quenched steel is a non-equilibrium grain boundary segregation phenomena occurred during cooling.

77. Curiously full of vitality, But a little frail and quenched. Her woman's instinct sensed it.

78. The hardness data of quenched steel under different conditions were collected utilizing austempering tests.