1. He pressed down the plunger of his cafetiere.

2. I bought a sink plunger to clear the blocked kitchen sink.

3. How can a sink plunger be so horrific?

4. Unfortunately, as the tranquillizer wears off so the plunger gradually slides back up and the former level of stress returns.

5. Push switch plunger inward to fully retracted position.

6. The plunger retraced at once.

7. Stainless steel material for pressure plunger.

8. Plunger pumps are single-acting and usually are motor-driven.

9. Cock and ball 2.3.3 : headstock were plunger or ball, rotating around its own axis.

10. The pump adopts isodiametric plunger, and there is no valve ball in its upper traveling valve housing.

11. Plunger mantle has a hexagonal structure and also is fitted with special tools.

12. Using hydraulic valve plunger interior unique structural design, but automatic control timing mechanism transmission gap, transmission lift of cam change, punctual make and break tire valve.

13. Odorization pumps are specially designed diaphragm plunger metering pump, plunger travel of the exercise machine lock, each time to maintain a constant output.

14. Die Casting Machine Supplies: plunger head , cylinder, piston oil spray, and so on.

15. Main oil vat: Adopt plunger type cylinder ( Germany technology ).

16. Reciprocating plunger seals have been substitute by mechanically or hydraulically actuated diaphragms in diaphragm pumps.

17. Through dynamic analysis, equations of plunger motion are derived and its cycle period is determined by solving problems.

18. A restoring spring is provided to press the plunger toward the armature.

19. As the plunger surface after processing by high - precision cylindrical grinder.

20. She depressed the plunger fully and pulled out the shot.

21. Ball Plunger Soft - tip socket set screw , socket screw , disc spring, dowel pins , springs pins , washers.

22. Crankshaft, piston, plunger piston, guider, guide rail, rotary drum, slide block, and various abrasive wear surface.

23. The motion of plunger of oleo damper excited by colored Gaussian noise with exponential correlation time is governed by first order nonlinear differential equation.

24. Pushing a broom handle up the tube will allow you to push the plunger up to this moulded shoulder and into the tube.

25. His left index finger pressed firmly on the telephone plunger as if he were extinguishing a burning cigarette.

25. is a sentence dictionary, on which you can find excellent sentences for a large number of words.

26. Bellows dispenser: These are wall mounted pumps hand operated by pushing a plunger set in a housing.

27. The comparison between measured and calculated values generally shows the same trend and the downgoing resistance of plunger increases with flow rate in both cases.

28. He grinds the meat in electric grinder, pushing it into the hopper with a wooden plunger.

29. When wells run at one or some of the above states, and the practical down stroke axial load of the plunger is greater than the critical axial load, the wear of rod string and tubing will take place.

30. The quantity of fuel delivering reduces with the wear of plunger pair and this tendeucy is more serious with reducing of pump speed due to the choking effect of plunger head restricting.

31. A plunger type quantitative lead pump belongs to the technology field of special pumps and is used for solving the problems with the lead pump, including high rate of wear and short service life.

32. In order to verify the performance of fracturing truck and plunger pump, bench test, final assembly test and field industrial test should be performed.

33. With the application of PCS intelligence plunger lift technique, the gas wells renew their production without any additional power.

34. FIGURE 6. Within a spring contact system, the points of transfer are where the tip meets the target, where the barrel and plunger meet, and where the barrel meets the printed circuit board.

35. The solenoid plunger pulls the vent valve down, blocking off the passage to the charcoal canister.

36. For assuring the maximum flow area at outlet of plunger, the outlet runner of plunger is supposed to be streamline, which would lower the flow resistance at outlet plunger.

37. The technologies of sintering, composite coating, punching plunger extruding, cold stretch and hot shrinkage, supercritical CO2-assisted extruding for PTFE are introduced.

38. The centrifugal force developed by the rotating flyweight sis translated into an upward force that lifts the plunger.

39. The plunger is seized in its guide ( sleeve ) .

40. With the car upside - down, the ball forces the plunger to seat against the guide plate.

41. The utility model discloses a special-shaped pipe expanding plunger chip and relates to a special-shaped pipe shaping tool.

42. Herefrom, the influence of plunger diameter and helical angle on dynamic process of engine speed adjusting system is emphatically analysed by means of computer simulation.

43. The clearance between plunger and barrel of a pump is a key parameter for the pump.

44. Subject unmated connector shall be mounted in a position of axial alignment of the contacts with the plunger of the test gauge to measure the withstand ability of the contact retaining system.

45. The calculating equation of the relative rotating angle in the leakage test of plunger and barrel assembly has been deduced by the geometric method.

46. Vaporisation from the needle on initial entry of the syringe into the injector, before the syringe plunger is depressed, can result in partial loss of high boiling components.

47. The effect, principle, application range, parameter analysis, design and well selection of an intelligent plunger gas lifting system are systematically studied.

48. The travelling valve of the pump is designed to be closed and opened forcibly, and the pump plunger adopts equal-diameter bare pipe with a floating structure to prevent gas lock and sand sticking.

49. Only by reasonably matching the factors can plunger gas lift be done normally.

50. The aim of the utility model is to design a special-shaped pipe expanding plunger chip with high pipe expanding efficiency and good quality.

51. TheNewcastleUniversityresearcher says the device works by pushing down the plunger, which opens a valve and mixes neutralizer moments before an injection is administered.

52. So as to enhance the life of the plunger valve.

53. The optimal effective thermal efficiency working zone and optimal effective thermal efficiency curve are defined and compared with traditional internal combustion engine driving plunger pump.

54. The utility model can efficiently prevent air locking phenomena and the eccentric wear of the plunger, increase the production quantity of raw oil and extend the service life of the oil well pump.

55. R 2 is the point of signal transfer between plunger and barrel.

55. Wish you can benefit from our online sentence dictionary and make progress day by day!

56. In addition, the completed programming has been used to analysis the influence of main-depute powder proportion, ignition delay of depute power and plunger mass on interior performance.

57. Consider an automation project that gathers wellhead data and controls the plunger lift cycles.

58. The formula for calculating the liquid shock load in the low sinking depth wells was set up, and the formula for the axial load in the down stroke of the plunger was established.

59. The position of the plunger cylinder is measured by a linear position transducer.

60. Riveting principle, plunger die str uctur e design and riveting process utilized in motor stator core superpose press are introduced and sums up the applying results.

61. Plunger shaft adopts integral structure, making installation easier and more reliable.

62. Both systems use the spring or plunger instability against its counterpart to create the bias effect.

63. Pull the pants down, stick it in me and push the plunger down.

64. The temperature-increase is an important factor effecting on stickingwear occurred between the plunger and the cylinder sleeve of a plunger pump.

65. Standard for the plunger surface activation showed uniform silver-gray, washed with water after activation. (3)Brush a.

66. A new method is proposed to determine the excited torque and bearing load of the injection pump camshaft by means of measuring the longitudinal strain in the bottom part of the plunger.

67. Plunger pump in the steering system bring fluid pulsation(Sentencedict), there out pressure pulsation in subsequence system.

68. The plunger released the waste and also sealed the soil pipe.

69. When the pump cylinder could not be filled with enough liquid, the liquid shock will occur, and the liquid shock load will make the down stroke axial load of the plunger increase.

70. G . Slowly advance the needle while gently withdrawing plunger of the syringe.

71. By introducing the technique of plunger gas lift, the optimal design of parameters and field operating prolong the flowing period effectively, and the better effect is gained.

72. This is often tail - fin shape plunger due to excessive thickness.