1. Quad 2-input NAND gate with schmitt trigger inputs.

2. So based on the theory of Schmitt trigger, the no-linear filter is designed, and it has been realized on the single chip computer.

3. The CMOS Schmitt trigger circuit with low voltage by the dynamic body - bias technology was presented.

4. This paper describes the single-limit voltage comparator, Schmitt trigger and window voltage comparator each of which incorporates only a second-generation current conveyor (CCII).

5. The interface circuit, which is based on the Schmitt trigger, works as a capacitor - frequency converter.

6. The threshold detector is similar to a Schmitt Trigger in that it is a latch circuit with a large dead zone.

7. This Schmitt trigger circuit can be suited to the deep sub-micron CMOS process and used to get rid of the noise on the input pad of the chip.

8. A single-supply low-power OTA-C relaxation oscillator based on the current-mode Schmitt trigger is presented.

9. If a proper RC feedback network is added to a schmitt trigger,[http://] we can get a two position (on-off) automatic controller with PID action.

10. This scheme uses optical cable to transmit signals and isolate high voltage, Schmitt trigger to dispose of signals, and microprocessor to identify the status of thyristor.

11. You can use a clamping circuit instead of a Schmitt trigger to clean up...

12. The A1210-A1214 Hall-effect latches include the following on a single silicon chip: voltage regulator, Hall-voltage generator, small-signal amplifier, Schmitt trigger, and NMOS output transistor.

13. When the input is high or low, the 555IC works on the Schmitt trigger condition, and the digital tube demonstrates H or L, which shows the input signal is at the high level or the low level.