1 Mandrel design was discussed in this paper.

2 Application: Mandrel built suction and discharge hose for conveying beer, wine vinegar, portable water and food stuffs.

3 Non - mandrel drawing is a method widely used in cold drawn pipe production.

4 The non - mandrel roll extrusion process of shaped tube was simulated using nonlinear FEM software.

5 This paper described the structure of the combined mandrel and the chopper—spray up device on the continuous winding machine.

6 After the mandrel is melted, a thin layer of alloy remains on the propellant surface.

7 The winding mandrel will be overhung type, mounted in two standard bearings.

8 Advantages of employment of semi - floating mandrel mill to produce small and medium tubes are elaborated.

9 Electroformed apertures reproduce the mandrel photo resist finish faithfully and do not require any further processing.

10 APPLICATION: For grid filaments, hooks, mandrel filaments and spark wires dicing etc. on electric source industry.

11 The mandrel construction method was chosen because it was determined to be easier and less expensive than continuous sheet piling construction.

12 They are made by winding resin-laced strands of carbon fibre round a mandrel and then curing in an oven.

13 Insert the handle crank to the faucet of the screw mandrel mechanism.

14 Furniture lights machinery:automatic car-teeth, tooth rolling machine, a shrunken pipe, tube machine, machine Tubes Drawn Without Mandrel, straighten machines, pipe cutting machines.

15 The calculation is mader for standard tools with a plug mandrel according to figure 4.

16 The winder will consist of an air expanded winding mandrel.

17 One way is to use a hollow billet and then use a fixed or floating mandrel.

18 It is found that the relative magnitude of the total effective plastic strain for inner and outer side of ring depends on reduction ratio, initial billet size and mandrel feed speed.

19 The ejector plate assembly's movement effectively withdraws the central mandrel from the collapsible sleeve thereby causing it to contract in diameter.

20 Top effort, mandril should have sufficient strength, should head out of uniform, mandrel not served as core.

21 P The reinforcement shall have adequate bendability to allow the use of the minimum mandrel diameters specified in Table 8.1 and to allow rebending to be carried out.

22 The rubber tube was expansed after inflated, then closed. The soft core that could be favourable to mandrel stripping was used to rubber special tube.

23 Through experiments, the method and values to ensure spinning technology parameters of no - mandrel roller were gained.

24 The results show that: the springback angle of bent tube increases with the bending angle, the gap between mandrel and tube, and the hardening coefficient, but decreases with the hardenability value.

25 At last, analyse comparatively the deformation and the microstructure of the rolling without mandrel and the rolling with mandrel of hollow drill steel.

26 A "position effect" usually occurs in cold bending test of ribbed steel bars, when the bending mandrel is misaligned with the bar surface.

27 The mechanical status of nutted rod in drawing pipe with short mandrel rod is analyzed, the analysis basis for the dimensions design of nutted rod offered.

28 The position control of side guider, pinch roll, and mandrel is very important for the whole coil area. It influences directly the success of coiling.

29 Existing systems are designed to erect META cases by forming and gluing a die-cut blank around a fixed mandrel, but the META KD - 8 creates an eight-sided box.

30 Introduce an experimental analytics axis - thrust tube bending on horn mandrel.