1. Exploring the mass transfer resistances during VMD process.

2. Heat and mass transfer process will not only affect the combustion temperature and gas distribution before the tuyeres but also affect the slag formation and pig iron quality in cylinder furnace.

3. The resistance and mass transfer property of ultrafiltration are analyzed, and the modified model of gelatification and polarization is established for the ultrafiltration process.

4. A new model for mass transfer of air bubble in water is established.

5. The minimum liquid—vapor ratio and the Height of Mass Transfer Unit "HTU" can be obtained in lack of interphase heat transfer coefficient by the model.

6. The mass transfer effect of MA when using absorption solution is better than using vacuum-pumping and sweep gas .

7. The heat and mass transfer model of chemical reactions in monolith was coupled to simulate the light-off characteristics of catalytic converter during cold start by CFD.

8. In this paper, the quasi-steady quasi-three-dimensional heat and mass transfer model in the tail water tunnel was found on the principle of thermal balance by using finite cell to control volume.

9. First of all, the fluid hydrodynamics and mass transfer characteristics on gas-liquid-liquid system in gas agitated extractor with static mixer was experimentally investigated.

10. Mass transfer mechanism, mathematical model and operating line equation of rectification - crystallization combination method in this article.

11. At constant gas flow rate, the overall volumetric mass transfer coefficients increase with the rotational speed.

12. Gas-agitation will improve the liquid-liquid contact and mass transfer in extraction column, and it has different effects on packed and spray columns.

13. Examples of interactions are mass transfer caused by temperature gradient.

14. The permeability and mass transfer effects of the immobilized yeast cells by staged hardening or by mixed coagulator were compared.

15. The resistance and mass transfer property of ultrafiltration are analyzed and the modified model of gelatification and polarization is established.

16. Adsorption model for TP mass transfer with XDA-1 resins was set up and the height of mass transfer zone and total mass transfer coefficient in different operation conditions were calculated.

17. After such studies, concentration profiles of the solutes are obtained as the solutions of the linear mass transfer equations.

18. From the experimental results, it can be inferred that the process of purifying the waste gas containing toluene in low concentration by using the biofilter is limited by mass transfer.

19. When the direction of the magnetic field strength gradient and the direction of the chemical potential gradient is identical, the effect of the mass transfer is best.

20. According to the polycondensation reaction balance and molecular diffusion of water balance and balance of mass transfer theory, the experimental phenomena was explained reasonably.

21. The magnetic field promoting the absorption of aqueous ammonia is a new field for enhancing heat and mass transfer.

22. An algebraically explicit analytical solution for governing equations of heat and mass transfer process in wet capillary porous media is derived.

23. Mass transfer and dispersion effects are included with the nonlinear mass transfer zone (MTZ).

24. The test results indicate that operation at high flue gas velocity improves the mass transfer effectively[http:///mass transfer.html], increases SO 2 removal efficiency significantly and decreases gas liquid ratio.

25. The research status on the mold filling of expendable pattern casting process is reviewed from the aspects of mold filling characteristics, heat and mass transfer.

26. In this paper theoretic and experimental researches on the heat and mass transfer on corrugated plate surfaces are carried out.

27. In this paper, an equation for the local blood-side Sherwood number is derived from the advancing front theory (AFT) for mass transfer of oxygen in a parallel plate membrane oxygenator.

28. The transverse motion of particle enhances the heat and mass transfer of material in the rotary kiln, and it is important for the optimal design and practical use of the equipment.

29. On the basis of above results, the mutual relationships among temperature, molten pool depth, mass transfer distance, parameters of the laser and properties of materials were carefully discussed.

30. As shown in practical operation, this technology has some advantages such as high efficiency of gas to liquid mass transfer, low liquid to gas ratio, no fouling and good adaptation of load etc.

31. Activity coefficient is an important parameter in aqueous speciation models, and plays an important role in describing the mass transfer between water and rock quantitatively.

32. The material is suitable for courses in equilibrium-stage processes, stagewise separation processes, mass transfer operations, separations processes, and rate-controlled separations.

33. A heat and mass transfer relation in a solar still was established and the steady state simulation experiments in a multi stage stacked tray distillation chamber were conducted.

34. The simulations on the tube and the primary experiments on the adsorber combined by the unit tubes indicate that the heat and mass transfer performance of the adsorption unit tube is very good.

35. The mass transfer coefficient is directly proportional to the cube root of feed velocity.

36. In this dissertation, press drying technology and properties of heat transmission and mass transfer of bamboo timber of Dendrocalamus giganteus were studied during press drying process.

37. Some virtue of the hypobaric and refrigerated preservation were testified by experimental study, and the model of heat and mass transfer was also testified that it is fit to the practical application.

38. The design part of the software can automatically finish most of the equipment design work for the centrifugal mass transfer machine.

39. The Mass transfer rate for the Oxidation of xylol in air by a monolithic Catalyst was experimentally determined.

40. The general rate model considering axial dispersion, film mass transfer and effective diffusion in particle was adopted to study the chromatography process of taxol and cephalmonnine.

41. Based on the penetration theory, a new semiempirical relationship for the prediction of the number of mass transfer units is given.

42. The software introduced in this article is for the design and operation of the centrifugal mass transfer machine.

43. In addition, the mass transfer coefficients could be obtained from the results of VMD, SGMD and DCMD experiments respectively.

44. The overall height of catalyst bed as well as the optimal feeding point was obtained for different detritiation efficiency under specific mass transfer coefficient of catalysts.

45. The idea that the analogy exists between heat and mass transfer unit methods is proposed.

46. It indicates the reduction of mass transfer efficiency of the structured packing at high pressure is mainly due to the effect of vapor backmixing and the subsequent liquid maldistribution.

47. There are two kinds of models for VOCs emission—the empirical model based on environmental chamber experiment and the theoretical model based on mass transfer theory.

48. The calculation of height of mass transfer zone and total mass transfer coefficient of adsorption column provides a basis for the design of size-enlarged plant.

49. Membrane modules with high porosity possess a high mass transfer coefficient.

50. Discussion on operating issue about absorption unit in mass transfer of chemical engineering is important whether in digesting content or in solving practical problems.

51. Mathematical model was proposed to determine rate constants of ozone self-decomposition in water and mass transfer coefficient of ozone.

52. The disposal and application of the zymotic orange peels are discussed, the drying mechanism of the orange peels and the law of thermal and mass transfer in drying process are researched.

53. Adsorbent permeability test unit was designed to study the mass transfer performances of the compound adsorbent.

54. The film spray non-back-mixing column plate can prevent the liquid from back mixing,[http:///mass transfer.html] and greatly improve mass transfer driving force and the column plate efficiency.

55. It also proved true the reasonability and serviceability of the new mass transfer process mechanisms.

56. The second part was about heat mass transfer models in moist sterilization process, from which the heat transport time could be theoretically calculated.

57. In addition, the experimental study and mass transfer kinetics of desulfurization, denitration and mercury removal in liquid phase were carried out.

58. When the temperature of heat source is relatively low, the falling film generator in the lithium bromide absorption machine can improve its heat and mass transfer performance.

59. Transport Phenomena for Chemical Reactor Design approaches the design of chemical reactors from microscopic heat and mass transfer principles.

60. The heat and mass transfer characteristic of carrot in the freeze-drying process is studied by the freeze-drying experiments of the middle and external part of carrot.

61. Two algebraically explicit analytical solutions of the governing equation set for the coupled heat and mass transfer process of rapid drying in porous media are derived.

62. Develops a numerical model the heat and mass transfer process in a packed type liquid dehumidifier.

63. The effect of controls parameters on mass transfer enhancement under pulsatile flow with backward flow condition is investigated.

64. Criterion for gas flow pressure loss is presented for rotating liquid film heat and mass transfer device.

65. According to the principle of mass conservation, the kinetic model of SCFE is set up founded on differential extraction, and the mass transfer in SCFE is analyzed.

66. Through the analyse and mathematical treatment, the equation of the adsorption capacity and the apparent mass transfer coefficient are obtained.

67. The correlations of the packing factor of pressure drop, packing factor of flooding point, and HTU of the true liquid phase mass transfer were obtained.

68. Wire mesh honeycomb combines a low pressure drop compared with powder catalyst and high mass transfer compared with ceramic honeycomb, mainly attributed to the high porosity of wire mesh structure.

69. Applies fins inside the reactor can enhance the convective mass transfer ability, and increase the reaction area.

70. Mass transfer in a trickle bed is calculated for the hydrogenation of diolefine over fibrous catalyst.

71. The results showed there exists certain effect of net structure of corrugated wire gauze Packings on its mass transfer performance.

72. Multiphase flow is a new and developing discipline on the basis of hydrodynamics, heat and mass transfer, physiochemistry , combustion theory and other disciplines.

72. is a online sentence dictionary, on which you can find excellent sentences for a large number of words.

73. In gas-liquid system, the bigger the resistance ratio of liquid side to gas side is, the more remarkable the enhancement of mass transfer by Marangoni effect becomes.

74. A rectangular aerobic fluidized bed reactor with round draft tube and a new type baffle device was designed to improve the radial mass transfer and the mix efficiency so to be convenient for scale-up.

75. Surface tension, one of the key influence factors to the mass transfer and reaction of multiphase system, is an important physical property of liquid.

76. A new model for describing mass transfer performance in the supercritical fluid ext raction columns by continuous counter current flow was derived.

77. The trapezoidal directed valve trays have excellent characteristics for hydrodynamics and mass transfer.

78. The straightforward visualization measurements improved the understanding on the mechanisms of gas-liquid mass transfer and micromixing inside a droplet.

79. When nitrogen passes through the pulser, nitrogen distributor and nozzle, into crystallizing tube, the heat-transfer and mass transfer in crystallizing process are strengthened.