1. The test value obtained through distillation pretreatment better approaches the true value.

2. There was no significant difference between the test value of male andfemale students on ASSR.

3. When the production line is in operating, test value of power of drawn wheel is 10% more than that of calculation. It is proved the above calculation method is correct.

4. There was no significant difference between the test value of male and female, left and right ears and the different age on ASSR.

5. Result shows that test value has a good agreement with calculated value obtained from a simple beam experiment, and the deflection error is less than 2%.

6. Test value of drive power is 5 9% higher than the calculation value. Thus, the above calculation method is proved correct.

7. The test value is in good accordance to the monitoring result, with all the error values being acceptable.

8. In addition, the contact resistance also influences the test value.

9. Caused by successive years of decline in lung capacity test value for many reasons, one of the most important reasons are: lack of effective physical training methods and not enough physical exercise.

10. Very low residue and few causticity , with high-surface insulation resistance value , no need to wash it also can reach the excellent ICT test value .

11. Each kind of boring method has the different effect on the original state of silty sand, so the standard penetration test value N obtained are certainly different.

12. A simulative calculation was conducted of the natural frequencies of the frame towers using large-scale finite element program ANSYS, and the calculated value was compared with the test value.

13. Results show that error between calculated analysis result of CMSM and test value of bridge is small. It verifies feasibility of CMSM.

14. All right? So if I called sqrt alone, that return test value is done, but in this case I bound it to test, so I can go look at test, and there it is.

15. Using statistical backward elimination method, the mathematic model was established for the relativity between cupping test value (IE) and mechanical properties of 9 kinds of steel sheet.

16. The difficulty of high speed asynchronous motor's design is analyzed, the relative measure is indicated, the design of rotor is proposed, design and test value is introduced instance at last.

17. The rigidity calculation of the closed thin - walled section rod structure of aircraft is carried out by using finite element method and the result tallies with the full - scale test value well.

17. is a sentence dictionary, on which you can find excellent sentences for a large number of words.

18. The maximum arresting hook load of model simulation value was compared with test value using the BAK-13 arresting gear and several kinds of aircrafts.

19. The BASIC programme made out is applicable in 7 modes making regression and analysis of the shearing rate, stress and test Value of various Newtonian and non-Newtonian fluid oil.

20. The results showed that potassium application could raise the SPAD-502 chlorophyll test value, promote citrus tree growth, increase fruit yield and improve quality.

21. The results show that beam offset can greatly affect the macro performance of Laser tailor-welded weld , then affect the cupping Test value and tensile strength unconspicuous.

22. The compressive modulus of Elasticity of the butanone rubber gasket are given, based on the compressive test Value of this type gasket, with the analysis and inference method by the authors.

23. Firstly to establish a reasonable crispness evaluation system after correlate analyses of sensory test and penetrometry test , and decided to select sensory test value as the main test index.