1. S2 may subsequently reset the bistable and cancel operation.

2. Fig. 3 shows the symbol for an S-R bistable.

3. The bistable will now be in a stable condition.

4. In this way,[Sentence dictionary] a single D-type bistable can remember one binary digit - or 0 or a 1.

5. Operation of the D-type bistable may be illustrated using the circuit shown in Fig. 10.

6. The clocked S-R bistable can be built using the Plugblock layout shown in Fig. 9.

7. Control principle is introduced, and acoustooptical bistable (AOB) system is taken as a typical example to demonstrate the effectiveness of this method.

8. These batteries are fine for simple electronics, and bistable displays.

9. Modulations of control parameter on chemical bistable system is investigated by using of parameter modulation method.

10. A bistable storage device which stores binary data as states of flip - flop elements.

11. Each tristable lattice structure unit consists of four bistable slices, wherein the four bistable slices are connected through bolts or glued joint.

12. Bistable Trigger Circuit A trigger circuit that has two stable states.

13. Bistable optical device's modulating function and electro optical feedback function are a group of non linear equation.

14. Self-perpetuating relay is a bistable relay which is low power consumption, stably working and is driven by impulse.

15. Bistable stochastic resonance method is proposed for the detection of time-varying underwater acoustic line-spectrum detection and the parameters can be used in detection system are presented.

16. Otherwise, the intracavity modulating laser with feedback device can be used in digital optical communication because of its bistable and multistable out-put.

17. The simulation results showed that after shifting the input frequency to a small one, the output power spectrum peaks of the bistable system were strongly enhanced at this frequency.

18. We find that the permeability and the resonance frequency can be adjusted by the DC bias magnetic field, and the bistable characteristic arises under certain conditions.

19. The section introduced working principle and manufacture technology of zenithal bistable nematic LCD.

20. It is confirmed that high contrast ratio of over 100 and reflectance of 100% with polarized light input are possible for such reflectance bistable displays.

21. Now that Apple iPad has paved the way, e-reader makers could also be re-evaluating the LCD as an alternative to the bistable, low-power but black-and-white E Ink display.

22. We study numerically the effect of signal modulating noise in bistable stochastic dynamical systems.

23. In this paper a new method of using double feedback proces to improve static stability of optical bistable device is presented.

24. This part also carries on computational analysis of simple model to the DMD bistable condition.

25. First, we would introduce fundamental Current-Voltage characters of the bistable resistive switching behavior.

26. To improve beamforming under low signal-to-noise ratio, a method based on stochastic resonance(SR)in a bistable model is investigated by using a frequency scale transformation method.

27. By combination of existed technology, the clue of development of large screen display by bistable technology is presented.

28. In this paper we discuss the design of fast framerate Bistable Chole-steric Texture(BCT)reflective displays.

29. It is found that the system will be in monostable state or bistable state, which is controlled by the competition between the uniaxial anisotropy and the exchange anisotropy of the system.

30. It takes a long time to get the SNR curve of a simplest bistable system because the ensemble average must be applied to the system .

31. In this paper, the reasons why the tuned substrate self-bias jumped discontinuously and was bistable are revealed, and the factors affect the characteristic are given.

32. The nonlinear response in the bistable system with a random binary signal by adding the variable amount of noise is studied, and the input-output cross-correlation coefficient is measured.

33. A bistable optical device must be constituted by a feedback function and a modulating function.

34. The section introduced working principle, manufacture technology and experiments of twist nematic bistable LCD.

35. The contrast ratio of reflective bistable twisted nematic displays are optimized by means of a parameter space approach.

36. Binary numbers, which consist of the digits 0 and 1, can represent conveniently the two states of a bistable device.

37. It shows that the self-pumping type and pump-probe types bistable switching can both be realized in the same structure, and the latter can separate the pump and signal in frequency and space.

38. Experimental results show that the bistable of tuned substrate self-bias was determined by discharge gas pressure,[http:///bistable.html] discharge power and tuning circuit parameters etc.

39. The stochastic resonance(SR)in an optical bistable system under the simultaneous action of multiplicative and additive noises and periodic signal is studied using the adiabatic approximation theory.

40. Spectrum analysis in output signal of bistable system can identify the frequency of weak sinusoidal signal concealed in the white noise.

41. The receiver structure based on discrete-time bistable system is designed for the constant binary signal detection, and it is compared with the matched filter in some cases of non-Gaussian noise.

42. Bistable optical devices modulating function and clectro- optical feedback function are a group of non- linear equation.

43. According to threshold characteristics of bistable structures and working principle of acceleration switch, this paper established adhesion bistable micro-acceleration switch models.