1. Route sensor wire from steering knuckle to fender panel.

2. Remove the steering knuckle from the strut.

3. A steering knuckle is the key component in cars, which needs high requirements in dimensional accuracy and product quality.

4. Macro and micro structure of the fractured steering knuckle arm was examined by optical microscope and scanning electron microscope.

5. A worn steering knuckle arm on a motor vehicle may cause heavier steering operation, the reasons are studied in this paper according to the steering trapezium principle.

6. The steering knuckle then supported through Ball joints, by upper and lower control arms which are attached to the car frame.

7. Lots of well-forged, normatively heat-treated, and elaborately-processed steering knuckle arms, pitman arm, idler arm pendulum lever etc, can be used widely as parts of various types of truck and car.

7. try its best to gather and create good sentences.

8. Place the entire steering knuckle assembly in a vise and re - drill using the # Q drill bit.

9. With the steering gear meshing steering rack level arrangement, the both sides with change the steering knuckle tie rod through a ball place to be connected.

10. It was presented that a new precision forming technology of car steering knuckle in this paper.

11. The results show that the thermomechanical treatment can improve the quality of the automobile steering knuckle.

12. It consists of steering wheel, steering shaft, worm, gear sector, pitman arm drag link, steering knuckle arm, king pin, steering arms, tie rod, front axle and steering knuckle.

13. Steering axis inclination is the inward tilt of the steering knuckle at the top.

14. The knuckle arms are secured by keys in the holes of the steering knuckle.

15. This backplate requires modification prior to installation on the steering knuckle.

16. The authors carried out a fracture failure analysis for a steering knuckle arm, and concluded that the part failure was caused by fatigue.

17. On single-ended output's gear rack type diverter, a rack's end with changes the steering knuckle tie rod through the inside and outside bracket to be connected.