1. To debug the system on EPROM.

2. All programs are stored in 12 K EPROM.

3. EPROM( Erasable Programming Read Only Memory) programming device is depicted; its system configuration, operation principle, software design and some flow charts are stated accordingly.

4. Introduced latent energy of EPROM & its design and application.

5. These sockets are used in EPROM programmers, burn-in boards and test jigs.

6. EPROM devices is used widely for microcomputer system and computer application field.

7. This is the surface of an EPROM (Erasable Programmable Read-Only Memory) silicon microchip.

8. The bootable image is created along with interfaces with the server's boot Read-Only Storage (ROS) and Erasable Programmable Read-Only Memory (EPROM).

9. Then the writer applies a programmable chip named EPROM instead of MC33035 and endues affluent and dexterous functions on the control system. It is excellent for high-power dynamoelectric cars.

10. Once erased, an EPROM can be reprogrammed with the help of a device programmer.

11. This paper describes the mechanism of an EPROM (erasible programmable read-only memory) and the fast-writing mode.

12. EPROM : Short for Erasable Programmable Read Memory. A read memory that can be erased and reprogrammed.

12. try its best to gather and build good sentences.

13. Once erased an EPROM can be reprogramed with the help of a device prograer.

14. To Embed the control program debugged successfully into EPROM and debug the system on EPROM.

15. EPROM: in full erasable programmable read-only memory, Form of computer memory that does not lose its content when the power supply is cut off and that can be erased and reused.

16. The article gives the principle, method and applied example of the EPROM used as sequential circuit design.

17. However, the A 29040 can also be programmed in standard EPROM programmers.

18. Procedure of the writing into a programmable read-only memory (PROM), or variants, such as EPROM.

19. The voltage output is supplied to a load, for example, the word line of an EPROM memory circuit.

20. A new method is proposed for realizing the finite automaton with EPROM.

21. The program is assembled to object code and is written in EPROM chip finally.

22. It can take a couple of hours to dump a thousand telephone numbers into a 128k EPROM pack.

23. This discourse introduces the method of how to design time controller circuit by assembling EPROM programmable memory.

24. Under the radiation of high POwer microwave ( HPM ) the series of 27 -- EPROM present temporaryand Permanent failure.

25. The function of the control program, stored in the 4 K EPROM already, has eight kinds of capability.

26. For such applications program are fixed and are written into ROM or EPROM of the microcontroller.

27. The capability of in - system - programable avoids the iterative pulling and plugging of EPROM.

28. The report introduces how to bootload a TMS 320 VC 5402 chip by using a parallel EPROM chip.

29. The device can also be programmed or erased in standard EPROM programmers.

30. Anti - fuse is widely used in FPGA, DRAM, PROM, EPROM chips.

31. EXE is executed, read operation of EPROM is permitted and its correctness is checked automatically.

32. The program is assemblied to object code andis written in EPROM chip finally.

33. Reading data out of the device is similar to reading from other Flash or EPROM devices.